Timberk SWH RE11 80 V - Инструкция по эксплуатации - Страница 9

www.timberk.com • electrical storage water heater

9

1. The water heater is designed to be connected to 220V~ single-phase 

electric main. Prior to connecting make sure that parameters of the electric 

main in the place of connection correspond to parameters, specified on the 

identification plate with technical parameters of the appliance. You should 

follow the current electrical safety code when installing the water heater.
2. The power outlet must be properly grounded. The outlet must be 

designed for rated current not less than 10A, electric cable with copper 

core must have cross section not less than 3x1.5 mm

2

 (for copper).

The power outlet and plug must always be dry to prevent current leakage. 

Regularly check if the power plug is tightly connected to the outlet. Do 

it in the following order: insert the power plug into the outlet, switch off 

the water heater after half-hour operation and unplug the cord, check if 

the plug is heated by your hand. If the plug is heated over 50°C, then to 

prevent damages, accidents and fire as a result of bad electrical contact, 

replace the outlet with a new one. A specialist must do this.

1. At first, open one of the separable taps at the water heater outlet, then 

open the inlet tap. The electric water heater will start filling with water. 

When water flows from separable tap freely, it means the water heater is 

fully filled with water and you can close the separable tap.

2. Plug the power cord into the outlet.

IMPORTANT! 

To provide reliable operation and safe use of the 

water heater, prior to the first run check if it is properly 

connected to the 220V~ AC mains. The water heater to 

be connected must be securely linked with the earth 

circuit of your electric mains.  The waterheater must be 

grounded properly, otherwise it is extremly dangerous 

for life safety.

8. WATER HEATER OPERATION

NOTE:

During normal operation the cold water supply valve 

must be opened.

Fig.8

IMPORTANT! 

The outlet must be designed for rated current not less 

than 10A, electric cable with copper core must have 

cross section not less than 3x1.5 mm2 (for copper).