Sony DCR-TRV20E - Инструкция по эксплуатации - Страница 176

176

En g l i sh

Tro u b l e sh o o t i n g

If you run into any problem using your camcorder, use the following table to troubleshoot the
problem. If the problem persists, disconnect the power source and contact your Sony dealer or local
authorized Sony service facility. If “C:

ss

:

ss

” appears on the LCD screen or in the viewfinder, the

self-diagnosis display function has worked. See page 182.

I n  t h e  r e co r d i n g  m o d e

Sympt om

Cause and/ or Correct ive Act ions

• The POWER switch is not set to CAMERA.

c

Set it to CAMERA. (p. 21)

• The tape has run out.

c

Rewind the tape or insert a new one. (p. 20, 39)

• The write-protect tab is set to expose the red mark.

c

Use a new tape or slide the tab. (p. 20)

• The tape is stuck to the drum (moisture condensation).

c

Remove the cassette and leave your camcorder for at least
one hour to acclimatize. (p. 195)

• While being operated in CAMERA mode, your camcorder has

been in the standby mode for more than five minutes.

c

Set the POWER switch to OFF (CHG) and then to CAMERA
again. (p. 22)

• The viewfinder lens is not adjusted.

c

Adjust the viewfinder lens. (p. 25)

• STEADYSHOT is set to OFF in the menu settings.

c

Set it to ON. (p. 116)

• FOCUS is set to MAN.

c

Set it to AUTO. (p. 65)

• Shooting conditions are not suitable for autofocus.

c

Adjust to focus manually. (p. 65)

• The digital effect function is working.

c

Cancel it. (p. 60)

• The LCD panel is open.

c

Close the LCD panel. (p. 23)

• The contrast between the subject and background is too high.

Your camcorder is not a malfunction.

• Your camcorder is not a malfunction.

• Slow shutter, low lux or Super NightShot mode is activated.

This is not a malfunction.

• If 10 minutes elapse after you set the POWER switch to

CAMERA or DEMO MODE is set to ON in the menu settings
without a cassette inserted, your camcorder automatically
starts the demonstration.

c

Insert a cassette and the demonstration stops.
You can also cancel DEMO MODE. (p. 121)

START/STOP does not operate.

The power goes off.

The image on the viewfinder screen
is not clear.

The fader function does not work.

The autofocusing function does not
work.

The SteadyShot function does not
work.

The picture does not appear in the
viewfinder.

An unknown picture is displayed on
the LCD screen or in the viewfinder.

A vertical band appears when you
shoot a very bright subject.

Some tiny white spots appear on the
LCD screen or in the viewfinder .

A vertical band appears when you
shoot a subject such as lights or a
candle flame against a dark
background.