Велокомпьютеры VDO MC1 0 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
3
GB
MC
1.0
1.Mounting
1.1 Mounting the handlebar holder
The handlebar holder fits handlebars of any diameter. Before mounting the system, decide if you will be using your left or right hand to operate the computer
and then mount the handlebar holder on the respective side. Position the handlebar holder, insert the strap and adjust is by tightening the screw.
Warning:
Before tightening the handlebar holder, make sure to adjust the position of the computer head (inclination) when the LCD-display is best
visible for you. Only when you find the best position tighten the screw.
P1
1.2 Mounting the speed transmitter / sender
The sensor should be mounted on the same side of the fork as the holder is on the handlebar. Make sure to position the respective rubber shim between
fork and sender, position the curved back of the sender next to the spokes and make sure the sender is aimed at the receiver (computer head).
Important:
Do not tighten the cable ties yet. Accurately position the sensor and the spoke magnet first, then tighten the cable ties.
1.3 Mounting the spoke magnet
Distance between magnet and sensor should be approx. 1-5 mm. In case this distance is not achievable in the current position, slide the sensor and the
magnet on the fork or spoke accordingly. The center of the magnet must be positioned to the marking on the sender. See fig.
P2+P3
