Fulgor Milano CPH 1124 G WK X - Инструкция по эксплуатации - Страница 24

24

25

GB

Adaptation to varius types of gas (Fig. 12)

Should the appliance be pre-set for a different type of 
gas than available, procreed as follows:
•  replace the injector (Fig. 7) with the corresponding  type 

of gas to be used (see table “User characteristics“);

Wok only

Fig. 12

Procedure for adjusting the minimum burner flow

The procedure for setting minimums allows the operator to 
change minimum flow setting, adapting each burner to the 
characteristics of the gas distribution system to which the 
cook top is hooked-up. 
The procedure is activated by holding down the + and - 
keys of burner A together with the + and - keys of burner D 
for 3 seconds, with all the burners off for a 4-burner model 
while, for a 5-burner model, hold down the + and - keys of 
burner A together with the + and - keys of burner E. 
The display indicates the activation of the procedure with 
“MIN”. At this point, you can select the burner to adjust by 
pressing the P+ and P- keys. After confirming with the PT 
key, the selected burner will light at the minimum and you 
will be able to increase or decrease the minimum flow by 
pressing the + and - keys for that burner. During regulation, 
the flame level display will show -, if the minimum set is the 

factory setting, and will display a flashing ^ or v to indicate, 
respectively, a higher or lower flow than the factory setting. 
To confirm the minimum flow desired, you must press the 
PT key. “MIN” will remain displayed and no LEDs will flash, 
so, at this point, you can press PT to exit the procedure 
or press the P+ or P- keys to select another burner and 
set the minimum flow. The minimum flow levels are then 
acquired and stored by the device and will be used during 
normal use of the cook top.

Selecting the type of fuel gas

You can configure the cook top to work with different 
gases (see table 1). To select the fuel gas to use, the 
cook top must be on with all the burners off. Just press 
the burner A, burner B and P- keys together for at least 2 
seconds. When the fuel gas selection procedure starts, 
the burner level display turns off and the timer display 
shows “2020”, “3029”, “2525” or “2010”, depending on 
the current configuration in use. It is possible to select 
the desired setting with the P+ and P- keys. To end the 
procedure, you must press the PT key.
Using this function deletes any turn-off times that may 
have been programmed for the burners.

Electronic self-test

The electronic cards are continuously checking their 
status. If there are any hardware or board problems that 
could affect the end-user's safety, the cook top goes 
into a “safe” mode which closes the solenoid valves and 
displays a code relative to failure.

Warnings for correct functioning of the flame detection 
circuit built-in to the appliance.

This device can be used in neutral phase 230V electric 
circuits, with neutral connected to earth.
The device must be adapted if used with electric circuits 
of different types.