FALMEC PIANO INDUZIONE PLUS - Инструкция по эксплуатации - Страница 16

16

ADDITIONAL FUNCTIONS
"38 FULL POWER" MODEL

STOP AND GO

This function allows to temporarily stop cooking and restore it with the same settings.
to enable touch the key  .
If the function is not deactivated within 10 minutes, the cooker switches of.

For deactivation

Touch the key    and within 5 seconds completely slide the slider to right.

AUTOMATIC PROGRAMMING OF THE COOKING

This function allows to speed up the start of cooking.
The procedure is the following:
1 - turn on the cooker
2 - touch for more than 2 seconds the desired level of cooking: 

on the display   will be displayed and the desired level of cooking 

.

For a certain period the cooking area will work at the maximum power to then rech the 
set level.

To deactivate the function:
touch again the control 

.

RESTORE FUNCTION 

After turning of the cooker, it is possible to restore the last selected settings:
· Status of cooking of all cooking areas (power).
· Minutes and seconds of the timer by programmed cooking areas.
· Automatic programming of cooking.

The restore procedure is the following:
- turn on the cooker.
· touch within 6 seconds the key  .
Previous settings are restored.

WHAT TO DO IN CASE OF PROBLEMS

The cooker or cooking areas do not turn on:

· The cooker is not connected to the electric network.
· The protection fuse is released.
· Check if the block is not active.
· Keys are covered with water or grease.
· An object is placed on the keys.

The symbol is displayed 

.

· There is no saucepan on the cooking area.
· The container used is not compatible with cooktops.
· The diameter of the saucepan bottom is too small compared to the cooking area.

The symbol [E] is displayed:

· Disconnect and connect the cooker.
· Contact the after-sales centre.

One of the area or the entire cooker turns of:

· The safety overheating system is active;
· The cooker or one cooking area remains on for too long;
· one or more keys are covered;
· one of the saucepans is empty and the bottom overheated.

The fan keeps on working after the cooker shutdown:

· This is not a malfunction: the fan keeps on protecting the electronic power unit of the 
device.
· The fan stops automatically.

The symbol [E2] or [E H] is displayed:

· The cooker overheated, leave it cool and then turn it on again.

The symbol [E6] is displayed:

· Defective electrical network. Check the network voltage and frequency.

The symbol [E8] is displayed:

· The air inlet of the fan is clogged, clean it.

CLEANING AND MAINTENANCE INSTRUCTIONS

ATTENTION!

For cleaning, never use a steam equipment.

Before cleaning the cooker, make sure that it is at room temperature.
Always clean the cooker after each use with a speciic cleanser for pyroceram.

Do not use products containing:
- corrosive agents (soda, acids, ammoniac).
- abrasive agents (dusts or paste).

Do not use pointed or abrasive objects.

After cleaning, dry the appliance with a soft cloth.

If the appliance is built-in over an oven or an electric kitchen itted with pyrolytic system 
do not operate it while the pyrolytic procedure is under way, as the overheating protec-
tion of the cooker can be released (see relevant chapter).

DISPOSAL AFTER END OF USEFUL LIFE

The crossed-out wheeled bin symbol on the appliance means that 

the product 

is WEEE

, i.e. 

"

Waste electrical and electronic equipment", accordingly 

it must not 

be disposed of with unsorted waste

 (i.e. with "mixed household waste"), but it 

must be disposed of separately so that it can undergo speciic operations for its 

re-use, or a speciic treatment, to remove and safely dispose of any substances that may be 
harmful to the environment and remove the raw materials that can be recycled. Proper dis

-

posal of these products contributes to saving valuable resources and avoid potential nega-

tive efects on personal health and the environment, which may be caused by inappropriate 
disposal of waste.
You are kindly asked to contact your local authorities for further information regarding the 
designated waste collection points nearest to you. Penalties for improper disposal of such 
waste can be applied in compliance with national regulations.

INFORMATION ON DISPOSAL IN EUROPEAN UNION COUNTRIES

The EU WEEE Directive was implemented diferently in each country, accordingly, if you wish 
to  dispose  of  this  appliance  we  suggest  contacting  your  local  authorities  or  dealer  to  ind 
out what the correct method of disposal is.

INFORMATION ON DISPOSAL IN NON-EUROPEAN UNION COUNTRIES

The crossed-out trash or refuse bin symbol is only valid in the European Union: if you wish 
to dispose of this appliance in other countries, we suggest contacting your local authorities 
or dealer to ind out what the correct method of disposal is.

WARNING!

The  Manufacturer  reserves  the  right  to  make  changes  to  the  equipment  at  any  time  and 
without prior notice. Printing, translation and reproduction, even partial, of this manual are 
bound by the ManufacturerЕs authorisation. 

Technical information, graphic representations and speciications in this manual are for in-
formation purposes and cannot be divulged.

This  manual  is  written  in  Italian. The  Manufacturer  is  not  responsible  for  any  transcription 

or translation errors.