Smeg SRV531X5 - Инструкция по эксплуатации - Страница 15

Instructions for the user

36

7.

USING THE  HOB 

Before turning on the burners, make sure that the burner rings, caps and 

grids have been fitted correctly. 
In the ultrarapid burner, notch 

A

 must be aligned with pin 

B

. 

Grid 

C

 provided is intended for use with woks (Chinese pans). 

Adapter 

D

 comes only with open grids models and is intended for use 

with small sized vessels. 

7.1

Ignition of the burners 

Raised indicators make for easier and clearer reading and use of the 
controls, each knob being connected to its corresponding burner by a 
rib. Setting corresponds to the elongated part of the knob or to the 
marking on it. 

(Only where applicable) 
Double-

crown

 burners, controlled by two knobs, feature two ribs, a long 

one corresponding to the small inner burner and a short one to the outer 
burner. 
Double-

crown

 burners comprise an auxiliary and a rapid burner, 

controlled by two different knobs which permit to use both burners at the 
same time or to select one or the other as required. 

The device is fit with electronic ignition. Simply press and simultaneously 
turn the knob counter-clockwise on the low point flame symbol, until the 
burner is ignited. Concerning models with valves, push the knob for 
approximately 2 seconds in order to keep the flame burning and to 
activate the safety device. The burner might go off when the knob is 
released. In this case repeat the aforesaid operation keeping the knob 
pressed for more than 2 seconds. 

Should the burners go off accidentally in the models with valves, a safety 
device will trip after approximately 20 seconds to block the gas outlet 

even if the tap is open.