MONSHER MSG 30 - Инструкция по эксплуатации - Страница 30

English

30

2.3 Wiring

  You should definitely use an earthed line for the product!

The manufacturing firm shall not be responsible for any damages that may occur if the product is used 

without the earth. 

 ОElectric shock, short-circuit or fire risk arising from the installation performed by any unprofessional 

persons! The product should be connected to the mains only by an authorized and qualified person and the 
warranty of the product starts only after correct installation. 

 Power shock, short-circuit or fire risk arising from damaged power cable! The power cable should be 

crushed, crinkled or pinched or should not contact with the hot parts of the product. If the power cable gets 
damaged, it should be replaced by a qualified electrician. 

B

The mains supply data should be same on the 

data indicated on the nameplate of the unit. You may 
find the nameplate at the back of or under the product. 

B

The connection cable of the product should 

comply with the technical specifications and power 
consumption. 

 Risk of electric shock! Before performing any work 

on the electric installation, please disconnect the power 

supply of the product.

2.4 Gas connection 

B

Any work on the gas equipment and systems should be performed by   the qualified and authorized 

persons. 

B

Prior to installation, make sure the conditions of local distribution (gas type and gas pressure) 

comply with the settings of the product. 

2.4.1  LPG connection

B

Make sure the gas hose and gas pressure-reducing valve you use on the range are safe. Connect 

the gas delivery hose with the hose behind the range and tighten it by using a clamp and screwdriver 
(figure 10). Make sure it is firmly tightened. 

B

Gas delivery hose of the equipment should not be longer than 1500mm. 

B

The pressure of the pressure-reducing valve to be used for LPG should 

be 300mmSS and certificated. 

 Gas delivery hose should not pass through the hot part behind the 

equipment. Temperature of the gas hose should not exceed 90°C (degree). 

Prior to use, make sure the system does not leak any gas.
1. 

G1/2 Nipple)

2.  Silicon seal
3.  G1/2 Hose inlet ( gas inlet)
4.  Metal clamp
5.  Gas hose (inner diameter 8mm)