Gorenje Plus GIT95XC - Инструкция по эксплуатации - Страница 29

GB 29

General

If you notice a crack in the glass top (however small), switch the hob 
off immediately, unplug the hob, turn off the (automatic) fuse switch(es) 
in the meter cupboard or, in the event of a permanent connection, 
set the switch in the power supply lead to zero.) Contact the service 
department.

Troubleshooting table

If the appliance does not work properly, this does not always mean that 
it is defective. Try to deal with the problem yourself first by checking the 
points mentioned below.

Symptom

Possible cause

Solution

Symbols (_.) appear in the 
displays when the hob is 
activated for the first time.

This is the standard set-up 
routine.

Normal operation.

The fan runs on for several 
minutes after the hob has 
been switched off.

The hob is cooling.

Normal operation.

A slight smell is noticeable 
the first few times the hob is 
used.

The new appliance is heating 
up.

This is normal and will 
disappear once it has been 
used a few times. Ventilate 
the kitchen.

You can hear a ticking sound 
in your hob.

This is caused by the capacity 
limiter on the front and back 
zones. Ticking can also occur 
at lower settings.

Normal operation.

The pans make a noise while 
cooking.

This is caused by the energy 
flowing from the hob to the 
saucepan.

At high settings this is 
perfectly normal for some 
pans. It will not damage either 
the pans or the hob.

You have switched on a 
cooking zone, but the display 
keeps flashing.

The pan you are using is not 
suitable for induction cooking. 
or has a diameter of less than 
12 cm.

Use a suitable pan, see  page 
11 and 12.

A cooking zone suddenly 
stops working and you hear 
a signal.

The preset time has ended.

Switch the bleep off by 
pressing any key.

TROUBLESHOOTING