VITEK VT-1764 BK - Инструкция по эксплуатации - Страница 4

4

 ENGLISH

•  

Do not cover the ventilation openings 
and avoid foreign objects getting inside 
them

.

•  Do not immerse the unit into water or 

other liquids.

•  

Do not move or tilt the unit during its op-
eration

.

•  

Always unplug the unit and pour out the 
water from the water tank when clean-
ing the unit or when you do not use it. 
Unplug the unit before moving it to an-
other place.

•  Do not touch the power plug with wet 

hands.

•  

Before using the unit, closely examine 
the power cord and make sure that it is 
not damaged. Do not use the unit, if its 
power cord is damaged.

•  

Do not disassemble the unit yourself, 
if any malfunction is detected, apply to 
the nearest authorized service center.

•  Regularly clean the unit; be careful not 

to make any scratches on the sprayer.

•  Store the unit out of reach of children.

FOR HOUSEHOLD USAGE ONLY

USING THE HUMIDIFIER

Unpack the unit and remove the packing 
materials. Examine the unit for damages. 
Do not switch on the unit if there are any 
damages in it.

Note: 
-  if the unit was subjected to negative 

temperatures, before switching it 
on for the first time, keep it at room 
temperature for 30 minutes. 

-  use the unit at temperatures from +5 

to +40°С, and relative humidity less 
than 80%. 

-  water temperature should not ex-

ceed +40°С.

Before switching on the unit, make sure 

that you home electricity supply corre-
sponds to the voltage specified on the 
body of the unit.

1.  Take the handle (10) and remove the 

water tank (11) from the body (17).

2.  Turn over the tank (11); unscrew the lid 

(15), by turning it anti clockwise. Fill the 
water tank (11) with necessary quantity 
of water and screw the lid on (15), by 
turning it clockwise.

3.  Set the filled tank (11) on the body of 

the unit (17). Wait for some time, which 
is necessary to fill the operating cham-
ber with water.

4.  Plug in the humidifier, the indication 

(21) will appear on the display (7); the 
room temperature (27) and humidity 
(28) will be displayed.

5.  Switch on the humidifier, by pressing 

the (5) “Power” on/off button, the in-
dication (21) will go out, the display will 
switch to full brightness and the steam 
intensity indication (26) will light up.

Note: 
-   each pressing of the control buttons 

will be accompanied with a sound 
signal.

-   if no button has been pressed dur-

ing 30 seconds on the control panel 
or on the remote control, the display 
brightness will decrease automati-
cally.

6.  To switch on the ionization mode, press 

the (6) “Ozone” button, the indication 
(25) will appear on the display (7). To 
switch off the ionization mode, press 
the (6) “Ozone” button once again, the 
indication (25) will disappear.

7.  To switch on the heating mode, press 

the (1) “Heating” button, the indication 
(22) will appear on the display (7).  In 
this mode the evaporated water will be 

4

1764.indd   4

1764.indd   4

04.06.2010   14:11:17

04.06.2010   14:11:17