Philips GC7805/20 - Инструкция по эксплуатации - Страница 9

11

Problem

Possible cause

Solution

No steam comes out of 
the soleplate, the light 
of the CALC-CLEAN 
button flashes and the 
appliance beeps.

You have not done or have 
not completed the Calc-
Clean process.

Perform the Calc-Clean process to enable 
the steam function again (see chapter 
'Cleaning and maintenance').

The appliance has 
switched off.

The safety auto-off function 
is activated automatically 
when the appliance has not 
been used for more than 5 
minutes.

To activate the appliance again, press the 
on/off button. The appliance then starts to 
heat up again.

The appliance produces 
a loud pumping sound.

The water tank is empty. 

Fill the water tank with water and press 
the steam trigger until the pumping sound 
becomes softer and steam comes out of 
the soleplate.

Water droplets come out 
of the soleplate.

After the Calc-Clean process 
remaining water may drip 
out of the soleplate.

Wipe the soleplate dry with a piece of cloth. 
If the Calc-Clean light still flashes and the 
appliance still beeps, perform the Calc-
Clean process (see chapter 'Cleaning and 
maintenance').

The Calc-Clean process has 
not been completed.

You have to perform the Calc-Clean 
process again (see chapter 'Cleaning and 
maintenance').

Steam condenses into water 
in the hose when you use 
steam for the first time or 
have not used it for a long 
time.

This is normal. Hold the iron away from the 
garment and press the steam trigger.Wait 
until steam instead of water comes out of 
the soleplate.

Dirty water and 
impurities come out of 
the soleplate.

Impurities or chemicals 
present in the water have 
deposited in the steam 
vents and/or soleplate.

Perform the Calc-Clean process regularly 
(see chapter 'Cleaning and maintenance').

Water flushes out of the 
soleplate.

You have accidentally 
started the Calc-
Clean process (see 
chapter 'Cleaning and 
maintenance').

Switch off the appliance. Then switch it 
back on again. Let the iron heat up until the 
'iron ready' light lights up steadily.

The Calc-Clean process 
does not start.

You have not pressed the 
CALC-CLEAN button for 2 
seconds until the appliance 
started beeping.

See chapter 'Cleaning and maintenance'.

The iron leaves a shine 
or an imprint on the 
garment.

The surface to be ironed 
was uneven, for instance 
because you were ironing 
over a seam or a fold in the 
garment.

PerfectCare is safe on all garments. The 
shine or imprint is not permanent and will 
come off if you wash the garment.Avoid 
ironing over seams or folds or you can 
place a cotton cloth over the area to be 
ironed to avoid imprints.

English