Philips Azur Advanced GC4938/20 - Инструкция по эксплуатации - Страница 6

ENGLISH

10

Problem

Possible cause

Solution

The iron is not hot enough yet 

to product steam.

Wait until the ‘iron ready’ light has 

stopped breathing and lights up steadily.

The ironing board cover 

becomes wet or there 

are water droplets on 

the garment during 

ironing.

The ironing board cover 

becomes wet or there 

are water droplets on the 

garment during ironing.

Replace the ironing board cover if the 

foam material has worn out. You can 

also add an extra layer of felt material 

under the ironing board cover to prevent 

condensation on the ironing board. You 

can buy felt in a fabric shop.

You have an ironing board 

cover that is not designed to 

cope with the high steam rate 

of the appliance.

Put an extra layer of felt material under

the ironing board cover to prevent 

condensation on the ironing board.

You can buy felt in a fabric shop.

Water droplets drips 

onto the garment 

during ironing.

You have used the steam 

boost function too often 

within a short period. 

Continue ironing in horizontal position 

and wait a while before you use the 

steam boost function again. 

You have not closed the water 

tank lid properly.

Press the lid until you hear a ‘click’.

You have not insert the Quick 

Calc Release collector properly 

back to the appliance (specific 

types only).

Stop ironing and let the iron cools down 

for at least 1 hour. Take out the Quick 

Calc Release collector. Insert it back into 

the appliance and ensure the collector is 

in-line with the surface of the appliance. 

Push down the lever (“click”). 

If the Quick Calc Release collector is 

damaged, contact a consumer care 

center in your country (see the world wide 

guarantee leaflet for contact details).  

The iron does not 

produce a steam boost.

You have used the steam 

boost function too often 

within a short period. 

Continue ironing in horizontal position 

and wait a while before you use the 

steam boost function again.

The iron is not hot enough for 

ironing yet.

Wait until the ‘iron ready’ light has 

stopped breathing and lights up steadily. 

You have put a chemical into 

the water tank.

Rinse the water tank and do not put any 

perfume or chemicals into the water tank.

Dirty water and 

impurities come out of 

the soleplate during 

ironing. 

Hard water with impurities or 

chemicals has formed flakes 

inside the soleplate.

Perform Quick Calc Release (specific types 

only) or Calc-Clean (specific types only).

See chapter “Cleaning and maintenance”.

Water drips from the 

soleplate after the iron 

has been unplugged.

You have put the iron in 

horizontal position with water 

still left in the water tank.

Empty the water tank after use, or store 

the iron in vertical position. 

The steam slider is set to 

.

Set the steam slider to 

.

There is an amber light 

flashing on the handle 

of the iron.

The Calc-Clean reminder light 

is activated. This is to remind 

you to perform calc clean. 

Perform Quick Calc Release (specific types 

only) or Calc-Clean (specific types only). 

See chapter “Cleaning and maintenance”.

The iron leaves a shine 

or an imprint on the 

garment.

The surface to be ironed was 

uneven, for instance because 

you ironed over a seam or a 

fold in the garment.

The iron is safe to use on all ironable 

garments. The shine or imprint is not 

permanent and disappears when you wash 

the garment. Avoid ironing over seams or 

folds. You can also place a cotton cloth over 

the area to be ironed to avoid imprints.