Ryobi RLT3123 5133002361 - Инструкция по эксплуатации - Страница 4

| English

2

from the power supply immediately. Do not 

touch the electric cables until the power 

supply has been disconnected.

■

Make sure the power cord is positioned so 

that it cannot be damaged by the cutting 

means and will not be stepped on, tripped 

over or otherwise subjected to damage or 

stress.

■

Never pick up or carry the product by the 

electric cable. 

■

Never pull by the power cord to disconnect 

from the power supply.

■

Keep the power cord away from heat, oil 

and sharp edges.

■

Make sure voltage is correct for your 

product. A nameplate on the product 

indicates the product’s voltage. Never 

connect the product to an AC voltage that 

differs from this voltage.

■

Make sure the switch is in Off position 

before disconnecting from power supply.

PREPARATION

■

Wear full eye and hearing protection while 

operating the product. If working in an area 

where there is a risk of falling objects, head 

protection must be worn.

■

Hearing protection may restrict the 

operators ability to hear warning sounds, 

pay particular attention to potential hazards 

around and inside the working area.

■

Wear heavy long trousers, boots, and 

gloves. Do not wear loose fitting clothing, 

short trousers, jewellery of any kind, or use 

with bare feet.

■

Secure long hair so it is above shoulder 

level to prevent entanglement in moving 

parts. 

■

Before use and after any impact, check that 

there are no damaged parts. A defective 

switch or any part that is damaged or worn 

should be properly repaired or replaced by 

an authorized service facility.

■

Make sure the cutting attachment is 

properly installed and securely fastened.

■

Never operate the product unless all 

guards, deflectors and handles are properly 

and securely attached.

■

Consider the environment in which you are 

working. Keep the working area free from 

wires, sticks, stones and debris which if 

struck by the cutter can become thrown 

objects.

LINE TRIMMER SAFETY WARNINGS

■

Never allow children, persons with reduced 

physical, sensory or mental capabilities 

or lack of experience and knowledge or 

people unfamiliar with these instructions 

to use the product. Local regulations may 

restrict the age of the operator.

■

Use the product in daylight or good artificial 

light.

■

Avoid using on wet grass.

■

Keep proper footing and balance at all 

times.

■

Do not walk backwards when using the 

product.

■

Keep firm footing and balance. Do not 

overreach. Overreaching can result in loss 

of balance. Always be sure of the footing 

on slopes, and walk, never run.

■

Keep bystanders, children and pets 15m 

away from the area of operation, stop the 

product if anyone enters the area.

■

Keep the cutting attachment below waist 

level.

■

Never operate the product with damaged 

guards or without guards in place.

■

Never fit a metal replacement line.

■

Keep hands and feet away from the cutting 

means at all times and especially when 

switching on the motor.

■

Beware, the cutting elements continue to 

rotate after the motor is switched off.

■

Beware of objects thrown by the cutting 

means. Clear debris like small stones, 

gravel and other foreign objects from the 

work area before starting operation. Wires 

or string may become entangled with the 

cutting means.

■

Switch off and disconnect from the power 

supply before:

●

servicing

●

leaving the product unattended

●

cleaning your product or clearing a 

blockage

●

changing accessories

●

checking for any damage after hitting an 

object 

●

checking for any damage if the product