Decker ST4525 - Инструкция по эксплуатации - Страница 7

7

ENGLISH

(Original instructions)

u

Only use the appliance in the upright 

position, with the cutting line near the 

ground. Never switch the appliance on 

in any other position.

u

Move slowly when using the appliance. 

Be aware that freshly cut grass is 

damp and slippery.

u

Do not work on steep slopes. Work 

across the face of slopes, not up and 

down.

u

Never cross gravel paths or roads 

while the appliance is running.

u

Never touch the cutting line while the 

appliance is running.

u

Do not put the appliance down until the 

cutting line has come to a complete 

standstill.

u

Use only the appropriate type of cut-

ting line. Never use metal cutting line 

or fishing line.

u

Be careful not to touch the line trim-

ming blade.

u

Take care to keep the mains cable 

away from the cutting line. Always be 

aware of the position of the cable.

u

Keep hands and feet away from the 

cutting line at all times, especially 

when switching on the motor.

u

Before using the appliance and after 

any impact, check for signs of wear or 

damage and repair as necessary.

u

Never operate the appliance with 

damaged guards or without guards in 

place.

u

Take care against injury from any de-

vice fitted for trimming the filament line 

length. After extending new cutter line 

always return the machine to its nor-

mal operating position before switching 

on.

u

Always ensure that the ventilation slots 

are kept clear of debris.

u

Do not use the lawn trimmer (edge 

trimmer), if the cords are damaged or 

worn.

u

Keep extension cords away from cut-

ting elements.

Electrical safety

#

This appliance is double insu-

lated; therefore no earth wire is 

required. Always check that the 

power supply corresponds to the 

voltage on the rating plate.

u

If the supply cord is damaged, it must 

be replaced by the manufacturer or 

an authorised Black & Decker Service 

Centre in order to avoid a hazard.

u

Electric safety can be further improved 

by using a highsensitivity 30 mA Re-

sidual Current Device (RCD).

Labels on appliance

The following warning symbols are found on the appliance:

Read the manual prior to operation.

Wear safety glasses or goggles when operating 

this appliance.