TCL 32S5400A - Инструкция по эксплуатации - Страница 8

EN

8

English

Getting started

Important

: 

Batteries shall not be exposed to excessive heat such as sunshine, fire or the like. Remove batteries when 

the remote control is not to be used for a long time. Batteries left in equipment may cause damage through 

deterioration and corrosive leakage, invalidating the guarantee.
To protect the environment use local recycling facilities for battery disposal. Dispose of used batteries 

according to the instructions.

CAUTION

: Risk of explosion if batteries are replaced by an incorrect type. Replace only with the same or 

equivalent type recommended by the equipment manufacturer. 
You can turn on the TV from standby mode by pressing the   button on your TV set.
While the TV is on, the multi-function menu appears by pressing the   button on your TV set. For more 

information about how to use the multi-function menu, please refer to the figure below.

Standby

Tips: Click to select options, press and hold to confirm.

Volume+

Source

OK

Volume-

CH-

CH+

• 

Press the 

 button to move the highlight to the next function selection.

• 

Press and hold the 

 button for more than 2 seconds to confirm your selection.

Note: Please refer to the Quick Start Guide to find the   button on your TV set.

Switch the TV on and off

1. 

When the power cord is connected, the TV will be turned on directly or be in standby mode. If the TV is in 

standby mode, press the   or 

POWER/

 button on the set or the   button on the remote control to turn it 

on.

2. 

To put the TV into standby mode, press the   button on the remote control. The TV set remains powered up, 

but with low energy consumption.

3. 

To switch the TV off, unplug the mains plug from the mains outlet.

Initial setup

The first time you switch the set on, the 

Welcome

 screen appears, which guides you through the initial setup 

process. Follow the on-screen instructions to finish the initial setup process such as selecting the language, 

connecting to the network, scanning channels, and more. During each step, either make a choice or skip the 

step. If you skip a step, you can perform the setup later from the settings menu. 

Note: If the channel search retrieved only the analogue channels it could be caused by poor broadcasting and 

therefore is not covered by manufacturer warranty. Manufacturers cannot be held responsible for lack of 

or poor broadcasting in some areas.