Panasonic TX-42CSR610 - Инструкция по эксплуатации - Страница 16

15

English

When pushed with a finger, the display panel moves 
slightly and makes a noise

●

There is a little gap around the panel to prevent 
damage to the panel. This is not a malfunction.

FAQs

Before requesting service or assistance, please follow 
these simple guides to solve the problem.

●

For more information, refer to [eHELP] (Support > 
FAQs).

The TV does not switch on

●

Check the mains lead is plugged into the TV and the 
mains socket.

The TV goes into Standby mode

●

Auto power standby function is activated.

The remote control does not work or is intermittent

●

Are the batteries installed correctly?   

(p. 11)

●

Has the TV been switched on?

●

The batteries may be running low. Replace them with 
new ones.

●

Point the remote control directly at the TV’s remote 
control signal receiver (within about 7 m and a 
30 degree angle of the signal receiver).

●

Situate the TV away from sunshine or other sources 
of bright light so they do not shine on the TV’s remote 
control signal receiver.

No image can be displayed

●

Check the TV is turned on.

●

Check the mains lead is plugged into the TV and the 
mains socket.

●

Check the correct input mode is selected.

●

Check the setting of [AV2] ([COMPONENT] / 
[VIDEO]) in [Input Selection] to match the output of 
the external equipment.

●

Is [Backlight], [Contrast], [Brightness] or [Colour] in 
the Picture Menu set to the minimum?

●

Check all required cables and connections are firmly 
in place.

Unusual image is displayed

●

This TV has a built-in Self Test. Makes a diagnosis of 
picture or sound problems.

[TV Self Test] (Help Menu)

●

Turn the TV off with Mains power On / Off switch, 
then turn it on again.

●

If the problem persists, initialise all settings. 

[Shipping Condition] in [System Menu] (Setup 
Menu)

Parts of the TV become hot

●

Parts of the TV may become hot. These temperature 
rises do not pose any problems in terms of 
performance or quality.