Строительные пылесосы Karcher WD 5P (1.348-194.0) - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.

– 8
–
The filling level of the filter bag depends on the dirt
that is sucked in.
–
The filter bag needs to be replaced more frequently
while sucking in fine dust, sand, etc.
–
Clogged filter bags can burst - therefore make sure
to replace the filter bag in a timely manner!
ATTENTION
Vacuum cold ashes only when using a prefilter.
ATTENTION
Do not use a filter bag!
Note:
If the container is full, a float closes the suction
opening, and the appliance works at a higher speed.
Switch off the appliance immediately, and empty the
container.
For vacuuming up moisture or wetness pay atten-
tion to the correct floor nozzle setting and connect
the corresponding accessories.
Adapt the adapter to the connection diameter of the
electric tool using a knife if necessary.
Illustration
A
) Plug the enclosed adapter onto the handle of the
suction hose and connect the electric tool with the
connection.
or
B
) Use the flexible tool hose to gain more flexibility
in your work. Connect this hose to the suction hose
and to the adapter and then to the connection of the
electric tool.
Illustration
For appliances with built-in socket
: Connect the
mains plug of the electric power tool to the vacuum
cleaner.
Illustration
-Switch the appliance on (move the rotary switch to the
left to position
MAX) and start working.
Note:
As soon as the electric tool is switched on, the
suction turbine starts with a 0.5 second delay. If the
electric tool is switched off, the suction turbine contin-
ues to run for approx. 5 seconds in order to vacuum up
the remaining dirt in the suction hose.
The filter cleaning system is intended for vacuuming up
large volumes of fine dust without an inserted filter bag.
Note:
Thanks to the filter cleaning system the soiled flat
pleated filter can be cleaned at the push of the button
and the suction performance can be increased again.
Illustration
Place the handle of the suction hose in the acces-
sory compartment on the appliance head. Push the
filter cleaning button 3 x while the appliance is
switched on, wait 4 seconds between the individual
operations.
Note
: After operating the filter cleaning button several
times, check the container for its filling volume. Otherwise,
the dirt might escape when the container is opened.
Cleaning hard to reach locations or, where vacuuming
is not possible, like leaves from a gravel bed.
Illustration
Connect the suction hose to the blower connection,
this will activate the blower function.
Illustration
Turn off the appliance.
Illustration
Hook the floor nozzle into the parking position.
Turn off the appliance and disconnect the mains plug.
Illustration
Remove the appliance head and empty the reser-
voir filled with wet or dry dirt.
For appliances with drain screw
: Empty the dry
dirt over the container. Use the drain screw to emp-
ty liquids.
Illustration
Stow away the mains cable and accessory at the
machine. Store the appliance in a dry room.
Clean the appliance and accessory parts made of
plastic with a commercial plastic cleaner.
If required, rinse the container and accessories
with water properly and dry them before reuse.
Recommendation: Clean the filter box after every use.
Illustration
Unlock, fold out and remove the filter cartridge,
empty dirt from the filter cartridge over a waste bin.
In order to clean the inserted flat fold filter, knock
the filter box against the edge of the waste bin. It is
not necessary to remove the flat fold filter from the
filter box.
If necessary, clean the flat fold filter separately.
Illustration
Unlock, fold out and remove the filter cartridge.
Illustration
Remove the flat fold filter from the filter box and tab
it out.
When necessary, clean under running water only,
do not wipe or brush down.
Allow to dry completely prior to use.
Finally, reinstall the dry flat fold filter into the appli-
ance. Insert the filter cartridge into the appliance.
Information filter bag
Wet vacuum cleaning
Working with electrical power tools
Integrated filter cleaning system
Blowing function
Interrupting operation
Finish operation
Empty the container
Storing the appliance
Care and maintenance
Clean flat fold filter
H
2
15
EN
Характеристики
Остались вопросы?Не нашли свой ответ в руководстве или возникли другие проблемы? Задайте свой вопрос в форме ниже с подробным описанием вашей ситуации, чтобы другие люди и специалисты смогли дать на него ответ. Если вы знаете как решить проблему другого человека, пожалуйста, подскажите ему :)