ARDESTO WMS-7117IWBD - Инструкция по эксплуатации - Страница 42

EN

Grounding introduction

•  A washer must have the grounding devices.  if a trouble 

happens, the device can reduce the risk of electrical shock. 

The device is equipped with a cable (including a wire and 

a grounded plug). The grounded plug must be inserted in 

an appropriate outlet. If you want to know if the washer 

is grounded correctly, please contact with professional 

maintenance staff. If the plug can’t match with outlet, 

please don’t change the plug by yourself.

•  Once your washer smokes or emits an odor, please cut the 

power and contact with professional maintenance staff.

Washers should be connected with water inlet. Please use 

attached new plumbing rather than the old.

In order to ensure the quality, water injection tests are 

carried out before the washer leaves factory, so there 

may be water inside the internal tub, door seals and door 

panel, which are normal.
Water inlet connection

ATTENTION! Do not connect to hot water!

1.  The pressure of supply water should be between 30kPa 

and 1000kPa.

2.  Don’t abrade the screw thread when connect the inlet 

pipes with valves.

3.  Please install dropping equipment 

if the pressure of supply water 

surpasses 1000kPa.

•  Two seals are supplied in the 

connectors of both ends of the pipe 

to prevent water leaking.

•  Turn on the tap and check if the 

connectors leak.

•  Check the pipes regularly. Please 

change them if necessary.

42