Kuppersberg WD 1488 - Инструкция по эксплуатации - Страница 27

27

ENGLISH

TECHNICAL PASSPORT

Washing Dryer Machines

OTHER ANOMALIES

Problem

Possible causes and practical solutions

The washing machine does 

not work/start

Make sure the product is plugged into a working supply socket.
Make sure power is on.
Make sure the wall socket is working, testing it with another appliance 

such as a lamp.

The door may not be correctly closed: open and close it again.

Check whether the required program was correctly selected and the 

start button pressed.

Make sure the washing machine is not in pause or time delay mode.

Water leaked on the fl oor 

near the washing machine

This may be due to a leak from the seal between the tap, supply hose 

and fi ll valve; in this case, replace it and tighten the hose connections 

correctly.

Make sure the front fi lter is correctly closed.

The washing machine does 

not spin

The machine is fi tted with a detection system that protects the load and 

product from damage if the load is not balanced before spinning. This 

may result in:-

The machine attempts to balance the load, increasing the time of spin.

Reduction of the speed of spin to decrease vibrations and noise.

The spin cycle aborting to protect the machine and load.

If this is experienced remove the load de-tangle it, reload it and restart 

the spin program.

This  could  be  due  to  the  fact  that  water  has  not  been  completely 

drained: wait a few minutes. If the problem persists, see Error 3 section.
Some models include a "no spin" function: make sure it is not selected.

Check which options are selected and their effect on the spin cycle.

Excessive  detergent  can  impede  the  spin  cycle,  ensure  the  correct 

amount of detergent is being used.

Strong vibrations / noises 

are heard during the spin 

cycle

The washing machine may not be fully levelled: if necessary, adjust the 

feet as indicated in the specifi c section.
Make  sure  transport  screws,  rubber  bungs  and  spacer  tubes  were 

removed.

Make  sure  there  are  no  foreign  objects  inside  the  drum  (coins,  hinges, 

buttons, etc. . .).

The standard manufacturer warranty covers faults caused by electrical or mechanical 
faults in the product due to an act or omission of the manufacturer. If a fault is 
found to be caused by factors outside the product supplied, miss-use or as a result 
of the instructions on use not being followed, a charge may be applied.