Kraft KF-MDS7107G - Инструкция по эксплуатации - Страница 41

41

USER GUIDE

AUTOMATIC WASHING MACHINE

TECHNICAL MAINTENANCE

All  electronic  components  (plug,  electric  cord,  compressor,  etc.)  must  only  be  re-

installed in certified service centers by qualified personnel.

In the event of a malfunction, you should always contact an authorized service cent-

er, specifying the type of problem and the model of your washing machine. Unqualified 
repair removes the device from warranty service. Only original spare parts can be used 
to repair the device.ли.

TROUBLESHOOTING

 During operation, if any malfunctions are detected that the consumer cannot elimi-

nate on their own, it is necessary to contact the service center for the repair of washing 
machines.

But before contacting the repair service, read this section. This list includes the most 

common cases that are not the result of poor assembly quality or poor-quality materials 
used in this device.

 ATTENTION! Before troubleshooting, you must disconnect the product from 

the  mains.  Troubleshooting  that  is  not  described  in  this  manual  should  only  be 

carried out by a qualified electrician or a competent technician.

Malfunction

Possible reason

Remedy

Program does not start 
after closing the door.

Start / Pause button was not 
pressed

Press the Start / Pause button

Washing machine has 
switched to self protection 
mode due to a supply 
problem

To cancel the programme, turn the Programme 
Selection knob to select another programme. 
Previous programme will be cancelled.

Machine vibrates or 
makes noise.

Machine might be standing 
unbalanced

Adjust the feet to level the machine

A hard substance might have 
entered into the pump filter

Clean the pump filter.

Transportation safety bolts 
are not removed.

Remove the transportation safety bolts

Laundry quantity in the 
machine might be too little.

Add more laundry to the machine.

Machine might be 
overloaded with laundry

Take out some of the laundry from the machine 
or distribute the load by hand to
balance it homogenously in the machine.

Machine stopped 
shortly after the 
programme started.

Machine might have stopped 
temporarily due to low 
voltage

It will resume running when the voltage restores 
to the normal level.