Kraft KF-MDS7107G - Инструкция по эксплуатации - Страница 40

40

USER GUIDE

AUTOMATIC WASHING MACHINE

WATER DRAIN FILTER CLEANING

 ATTENTION! To avoid getting burned, wait until the water left in the washing 

machine cools down! The water tap must be turned off!

Clean the water drain and fill filter every 6 months:

1.   Shut  off  the  tap  so  that  no  more  water  flows  in  and  has  to  be  drained.  Switch  the 

appliance off. Unplug the power plug. 

2.   Open the drain filter cover.  
3.   Use the pull-out drain hose located in the pump access opening to drain the remaining 

water into a suitable container (up to 5.3U.S.gallon/20 liters of water may be drained). 
Pull the sealing cap from the hose and lay the hose over the side of the container and 
allow the water to finish draining from the drum. When finished, replace the sealing 
cap into the end of the hose and restore the hose to its storage location. 

4.   Turn the pump cover counterclockwise to remove it. A small amount of residual water 

may  flow  out  when  the  cover  is  removed.  Clean  the  interior  of  the  pump  hosing, 
removing  any  debris  or  foreign  objects.  Check  to  be  sure  the  impeller  where  at  the 
back of the pump housing can now turn freely. Remove any lint, debris or detergent 
residue  from  the  threads  of  the  pump  cover  and  the  pump  cover  housing.  Replace 
the pump cover by screwing tightly into position. Handle must be vertically. 

5.   Close the drain filter cover. Wipe up any spilled water. .

WATER SUPPLY FILTERS CLEANING 

•   Turn  off  the  tap,  disconnect  the  hose  from  the  tap, 

and clean the filter screen with a small brush.

•   Disconnect  the  water  supply  hose  from  the  washing 

machine,  pull  out  the  filter  screen  with  pliers,  and 
install it back after cleaning.

•   Connect the filling hose, open the tap, and make sure 

there is no water leakage.

1

2

3

4

1

2

3

4