Ardesto JEG-800 - Инструкция по эксплуатации - Страница 17

17

EN

INSTRUCTIONS FOR USE

Before using your juice extractor

Follow the assembling instructions listed below before using your 

juice extractor:

1.  Before you start assembling your juice extractor, make sure it is 

unplugged and it is placed on a dry and leveled surface.

2.  Place middle ring on top of the motor base.

3.  Place the stainless steel filter on the middle ring, turning it until 

it fits into the grooves of the motor shaft.

4.  Place transparent cover on top of the filter.

5.  Raise the handle/safety locking arm and place it on the grooves 

on the sides of the transparent cover. This is a safety feature 

that will ensure the unit will not operate unless the transparent 

cover is properly locked. The safety locking arm should now be 

up and locked into place on top of the transparent cover.

6.  Place the juice cup under the spout located on the right hand 

side of the juicer.

OPERATING INSTRUCTIONS

1.  Prepare your fruits and vegetables by washing them 

thoroughly and peeling off those that need the skin 

removed.

2.  Your juicer features an extra wide chute and thus most 

fruits and vegetables such as apples, carrots, pears and 

others will not need to be cut into small pieces if they fit 

in the chute.

3.  Make sure your juice extractor is properly assembled. 

Please follow the instructions from the section “Before 

Using Your Juice Extractor.”

4.  Ensure the juice extractor and its accessories are clean by 

following the cleaning and maintenance section of this 

manual.

5.  Place the juicer jug or other container/glass you may wish 

to use to collect the juice under the spout. Do not allow