STATUS DP-1051 02142601 - Инструкция по эксплуатации - Страница 8

8

EN

GENERAL INSPECTION

Regularly inspect all fasteners and ensure they are properly tightened. Should any of the 

screws be loose, retighten it immediately to avoid hazards.

If the replacement of the supply cord is necessary, this has to be done by the manufacturer 

or his agent in order to avoid a safety hazard.

CLEANING

For safe operation always keep the machine and its ventilation slots clean.

Regularly check to see if any dust or foreign matter has entered the ventilation slots and the 

grills around the switches. Use a soft brush and/or air jet to remove any accumulated dust. 

Wear safety glasses to protect your eyes whilst cleaning. 

Exterior plastic parts may be cleaned with a damp cloth and mild detergent if necessary.

WARNING!

Never use alcohol, petrol or other cleaning agent. Never use caustic agents to   

clean plastic parts. Water must never come into contact with the tool.

REPLACEMENT PARTS

To assure product safety and reliability, repairs, maintenance and adjustment (including 

brush inspection and replacement) should be performed by authorised service centres 

always using genuine replacement parts.

MAINTENANCE

MAINTENANCE

AUXILIARY HANDLE

Tighten the auxiliary handle 6 on the drill journal. In the interests of safety, the auxiliary 

handle 6 should always be used. The depth gauge 7 can be used for fixing the depth of the 

drilled bores.