STATUS DP-1051 02142601 - Инструкция по эксплуатации - Страница 6

6

EN

• 

Prior to operation use suitable detectors to determine if utility lines are hidden in the 

work area or call the local utility company for assistance. Contact with electric lines can 

lead to fire and electric shock. Damaging a gas line can lead to explosion. Penetrating a 

water line causes property damage or may cause electric shock.

• 

Always keep the cord away from the working area of the power tool.

• 

Never use the machine with a damaged cable. Do not touch the damaged cable and 

pull the mains plug when the cable is damaged while operating. Damaged cables 

increase the risk of electric shock.

• 

Always be sure you have a firm footing. Be sure no one is below when using the tool in 

high locations.

• 

Use clamps or a vice to secure your work whenever possible.

• 

Watch out for the initial torque reaction of the machine or upon jamming the drill bit. 

Switch the power tool immediately upon jamming the drill bit. Watch out for high 

reactive torque which may result in kick-back. The drill bit will block if the power tool is 

overloaded or if the bit jams into the material.

• 

Do not touch the drill bit or parts close to it during operation and immediately after 

that; they may be extremely hot. You may get serious burns.

• 

Keep work area clean. Blends of materials are particularly dangerous. Dust from light 

alloys can burn or explode.

• 

Rags, cloths, cord, string and the like should never be left around the work area.

• 

Always switch the machine off prior to leaving it down.

• 

The tool must be used only for its prescribed purpose. Any use other than those 

mentioned in this Manual will be considered a case of misuse. The user and not the 

manufacturer shall be liable for any damage or injury resulting from such cases of 

misuse.

• 

To use this tool properly, you must observe the safety regulations, the assembly 

instructions and the operating instructions found in this Manual. All persons who use 

and service the machine have to be acquainted with this Manual and must be informed 

about its potential hazards. Children and frail people must not use this tool. Children 

should be supervised at all times if they are in the area in which the tool is being used. 

It is also imperative that you observe the accident prevention regulations in force in 

your area. The same applies for general rules of occupational health and safety.

• 

The manufacturer shall not be liable for any changes made to the tool nor for any 

damage resulting from such changes.

• 

The power tools must not be used outdoors in rainy weather, or in moist environment 

(after rain) or in close vicinity with easily flammable liquids and gases. The working 

place should be well lit.

SPECIFIC SAFETY INSTRUCTIONS