Ryobi ONE+ R18PD5-0 5133003595 - Инструкция по эксплуатации - Страница 4

immediately discontinue use and see your doctor about 

these symptoms.

 WARNING

Injuries may be caused, or aggravated, by prolonged 

use of a tool. When using any tool for prolonged periods, 

ensure you take regular breaks.

KNOW YOUR PRODUCT

See page 81.

1.  Gear selector (drill or hammer mode only)
2. Mode selector
3. Keyless chuck
4.  Direction of rotation selector
5.  Variable speed switch trigger
6.  Handle, insulated gripping surface
7. LED light
8. Bit storage
9.  Screw driver bit
10. Battery port

MAINTENANCE

 WARNING

The product should never be connected to a power supply 

when you are assembling parts, making adjustments, 

cleaning, performing maintenance, or when the product 

is not in use. Disconnecting the product will prevent 

accidental starting that could cause serious injury.

■

When servicing, use only identical replacement parts. 

Use of any other parts may create a hazard or cause 

product damage.

■

Avoid using solvents when cleaning plastic parts. Most 

plastics are susceptible to various types of commercial 

solvents and may be damaged by their use. Use clean 

cloths to remove dirt and carbon dust.

■

Do not at any time let brake fluids, gasoline, petroleum-

based products, penetrating oils, etc., come in contact 

with plastic parts. They contain chemicals that can 

damage, weaken or destroy plastic.

■

Always wear safety goggles or safety glasses with side 

shields during power tool operation or when blowing 

dust. If operation is dusty, also wear a dust mask.

■

For greater safety and reliability, all repairs should be 

performed by an authorised service centre.

LUBRICATION

All of the bearings in the product are lubricated with a 

suf

fi

 cient amount of high grade lubricant for the life span of 

the product under normal operating conditions. Therefore, 

no further lubrication is required.

ENVIRONMENTAL PROTECTION

Recycle raw materials instead of disposing 

of as waste. The machine, accessories and 

packaging should be sorted for environmental-

friendly recycling.

E-TORQUE CONTROL

e-Torque control is a technology which automatically drives 

most screws 

fl

 ush.

When in the auto screw driving mode the drill will stop once 

the screw is 

fl

 ush. If a deeper screw is required, continue 

depressing the trigger. The drill will begin small rotations at 

a manageable speed. Release the trigger once the desired 

depth is achieved.
When using e-Torque control it is important to ensure the 

screw bit is correctly seated and does not slip from the 

screw head. If the screw bit is incorrectly 

fi

 tted the drill may 

stop early to prevent damage to the screw head or bit. If 

this occurs, realign the bit with the screw head and depress 

the trigger again.

NOTE

: e-Torque control works with most materials and 

applications but may not operate with certain materials or 

screws, e.g., machine screws into metal or plastic threads.

SYMBOLS

Safety alert

CE conformity

V

Volts

Direct current

min

-1

Revolutions or reciprocations per minute

Chuck capacity

No-load speed

EurAsian Conformity Mark

Please read the instructions carefully 
before operating the product.

Ukrainian mark of conformity

Drilling without impact

AUT

O

Auto screw driving mode

Percussion Drill

Waste electrical products should not 
be disposed of with household waste. 
Please recycle where facilities exist. 
Check with your local authority or 
retailer for recycling advice.

2

| English