Ryobi ONE+ LLCDI18-LL99X 5133002482 - Инструкция по эксплуатации - Страница 9

4

English

GB

FR

DE

ES

IT

NL

PT

DK

SE

FI

NO

RU

PL

CZ

HU

RO

LV

LT

EE

HR

SI

SK

GR

TR

OPERATION

TORQUE ADJUSTMENT

When using the drill-driver for various driving applications, 

it becomes necessar y to increase or decrease the torque 

in order to help pre vent the possibility of damaging  

screw heads , threads , w orkpiece, etc. In gener al, torque 

intensity should correspond to the scre w diameter. If the 

torque is too high or the scre ws too small, the scre ws 

may be damaged or broken.
The torque is adjusted by rotating the torque adjustment ring.
The torque is g reater when the torque adjustment r ing 

is set on a higher setting.   The torque is less when the  

torque adjustment ring is set on a lower setting.
The proper setting depends on the type of mater ial and 

the size of screw you are using.

BIT STORAGE

When not in use, bits provided with the drill can be placed 

in the storage areas located on the base of the drill.

WARNING

:

Make sure to inser t the dr ill bit str aight into the 

chuck ja ws. Do not inser t the dr ill bit into the  

chuck ja ws at an angle then tighten.   This could 

cause the dr ill bit to be thro wn from the dr ill, 

resulting in possib le ser ious personal injur y or  

damage to the chuck.

NOTE:

 Rotate the chuc k body in the direction of the  

arrow mar ked 

LOCK

 to tighten the chuc k ja ws. Do not  

use a wrench to tighten or loosen the chuck jaws.

REMOVING BITS

■

Lock the switch trigger by placing the rotation selector 

in the center position.

■

Open the chuck jaws.

NOTE:

 Rotate the chuc k body in the direction of the 

arrow marked 

UNLOCK

 to loosen the chuc k jaws. Do 

not use a wrench to tighten or loosen the chuck jaws.

■

Remove the drill bit.

DRILLING

■

Check the rotation selector f or the correct setting  

(forward or reverse).

■

Secure the mater ial to be dr illed in a vise or with  

clamps to keep it from turning as the drill bit rotates.

■

Hold the drill firmly and place the bit at the point to be 

drilled.

See Figure 8.

INSTALLING BITS

■

Lock the switch trigger by placing the rotation selector 

in the center position.

■

Open or close the chuc k ja ws to a point where the  

opening is slightly larger than the bit siz e y ou intend 

to use. Also, raise the front of the dr ill slightly to k eep 

the bit from falling out of the chuck jaws.

■

Insert the drill bit.

■

Tighten the chuck jaws on the drill bit.

See Figure 8.

See Figure 2.

See Figure 7.