Makita HP002GZ - Инструкция по эксплуатации - Страница 7

7 ENGLISH

Indicating the remaining battery 

capacity

Press the check button on the battery cartridge to indi-

cate the remaining battery capacity. The indicator lamps 

light up for a few seconds.

► 

Fig.2:

1.

 Indicator lamps 

2.

 Check button

Indicator lamps

Remaining 

capacity

Lighted

Off

Blinking

75% to 100%

50% to 75%

25% to 50%

0% to 25%

Charge the 

battery.

The battery 

may have

malfunctioned.

NOTE:

 Depending on the conditions of use and the 

ambient temperature, the indication may differ slightly 

from the actual capacity.

NOTE:

 The first (far left) indicator lamp will blink when 

the battery protection system works.

Tool / battery protection system

The tool is equipped with a tool/battery protection sys-

tem. This system automatically cuts off the power to 

extend tool and battery life. The tool will automatically 

stop during operation if the tool or battery is placed 

under one of the following conditions:

Overload protection

This protection works when the tool or battery is oper-

ated in a manner that causes it to draw an abnormally 

high current. In this situation, turn the tool off and stop 

the application that caused the tool to become over-

loaded. Then turn the tool on to restart.

Overheat protection

This protection works and the lamp blinks when the tool 

or battery is overheated. In this situation, let the tool and 

battery cool before turning the tool on again.

Overdischarge protection

This protection works when the remaining battery 

capacity gets low. In this situation, remove the battery 

from the tool and charge the battery.

Switch action

CAUTION:

Before installing the battery car-

tridge into the tool, always check to see that the 

switch trigger actuates properly and returns to 

the "OFF" position when released.

To start the tool, simply pull the switch trigger. Tool 

speed is increased by increasing pressure on the switch 

trigger. Release the switch trigger to stop.

► 

Fig.3:

1.

 Switch trigger

NOTE:

 The tool automatically stops if you keep pull-

ing the switch trigger for about 6 minutes.

Electric brake

This tool is equipped with an electric brake. If the tool 

consistently fails to quickly stop after the switch trigger 

is released, have the tool serviced at a Makita service 

center.

Lighting up the front lamp

CAUTION:

Do not look in the light or see the 

source of light directly.

Pull the switch trigger to light up the lamp. The lamp 

keeps on lighting while the switch trigger is being pulled. 

The lamp goes out approximately 10 seconds after 

releasing the switch trigger.

► 

Fig.4:

1.

 Lamp

NOTE:

 When the tool is overheated, the tool stops 

automatically and the lamp starts flashing. In this 

case, release the switch trigger. The lamp turns off in 

one minute.

NOTE:

 Use a dry cloth to wipe the dirt off the lens of 

the lamp. Be careful not to scratch the lens of lamp, or 

it may lower the illumination.

Reversing switch action

CAUTION:

Always check the direction of 

rotation before operation.

CAUTION:

Use the reversing switch only after 

the tool comes to a complete stop.

 Changing the 

direction of rotation before the tool stops may dam-

age the tool.

CAUTION:

When not operating the tool, 

always set the reversing switch lever to the neu-

tral position.

This tool has a reversing switch to change the direction 

of rotation. Depress the reversing switch lever from the 

A side for clockwise rotation or from the B side for coun-

terclockwise rotation.

When the reversing switch lever is in the neutral posi-

tion, the switch trigger cannot be pulled.

► 

Fig.5:

1.

 Reversing switch lever