Makita HP002GZ - Инструкция по эксплуатации - Страница 4

4 ENGLISH

ENGLISH (Original instructions)

SPECIFICATIONS

Model:

HP002G

Drilling capacities

Masonry

13 mm

Steel

13 mm

Wood

Auger bit: 38 mm

Self-feed bit: 38 mm

Hole saw: 51 mm

Fastening capacities

Wood screw

10 mm x 90 mm

Machine screw

M6

No load speed (RPM)

High (2)

0 - 2,200 min

-1

Low (1)

0 - 600 min

-1

Blows per minute

High (2)

0 - 33,000 min

-1

Low (1)

0 - 9,000 min

-1

Overall length

174 mm

Rated voltage

D.C. 36 V - 40 V max

Net weight

2.0 - 2.9 kg

• 

Due to our continuing program of research and development, the specifications herein are subject to change 

without notice.

• 

Specifications may differ from country to country.

• 

The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi

-

est combination, according to EPTA-Procedure 01/2014, are shown in the table.

Applicable battery cartridge and charger

Battery cartridge

BL4020* / BL4025* / BL4040* / BL4050F

* : Recommended battery

Charger

DC40RA / DC40RB / DC40RC

• 

Some of the battery cartridges and chargers listed above may not be available depending on your region of residence.

WARNING:

Only use the battery cartridges and chargers listed above.

 Use of any other battery cartridges 

and chargers may cause injury and/or fire.

Intended use

The tool is intended for impact drilling in brick, brickwork 

and masonry. It is also suitable for screw driving and 

drilling without impact in wood, metal, ceramic and 

plastic.

Noise

The typical A-weighted noise level determined accord-

ing to EN62841-2-1:

Sound pressure level (L

pA

) : 87 dB(A)

Sound power level (L

WA

) : 98 dB (A)

Uncertainty (K) : 3 dB(A)

NOTE:

 The declared noise emission value(s) has 

been measured in accordance with a standard test 

method and may be used for comparing one tool with 

another.

NOTE:

 The declared noise emission value(s) 

may also be used in a preliminary assessment of 

exposure.

WARNING:

Wear ear protection.

WARNING:

The noise emission during actual use 

of the power tool can differ from the declared value(s) 

depending on the ways in which the tool is used espe-

cially what kind of workpiece is processed.

WARNING:

Be sure to identify safety measures 

to protect the operator that are based on an estimation 

of exposure in the actual conditions of use (taking 

account of all parts of the operating cycle such as the 

times when the tool is switched off and when it is run

-

ning idle in addition to the trigger time).

Vibration

The vibration total value (tri-axial vector sum) deter-

mined according to EN62841-2-1:

Work mode: impact drilling into concrete

Vibration emission (a

h,ID

) : 9.0 m/s

2

Uncertainty (K) : 1.5 m/s

2

Work mode: drilling into metal

Vibration emission (a

h,D

) : 2.5 m/s

2

 or less

Uncertainty (K) : 1.5 m/s

2