FERM FX Power CDM1164 - Инструкция по эксплуатации - Страница 9

9

EN

•   Position 1: For slow drilling, large drilling 

diameter or screw driving. The machine has 
high power at a low speed. 

•   Position 2: For fast drilling or small drilling 

diameter

Adjusting the direction of rotation (Fig. E)

•   Set the direction switch (9) to position 

 in 

order to drive screws or to use it for drilling. 

•   Set the direction switch (9) to position 

 in 

order to remove screws.

Switching the machine on and off (Fig. E)

The on/off switch (10) is used for activating the 
machine and adjusting rotation speed. 
•   Pressing the on/off switch (10) will activate 

the machine, the further the switch is being 
pushed, the faster the drill will turn.

•   Releasing the on/off switch (10) will stop the 

machine.

•   Move the direction reversing switch (9) to the 

middle position to lock the movement of the 
on/off switch.

Adjusting the torque (Fig. E)

The machine has 17 different torque settings 
and a special drill mode to set the power being 
transmitted to the chuck. 
By rotating the torque adjustment ring (11), 
screws can be driven to a predetermined depth, 
which is ideal for repetitive work. The higher the 
number, the more torque will be transmitted. 
•   Select a low setting for small screws or soft 

work material. 

•   Select a high setting for large screws, hard 

work materials and when removing screws. 

•   You should preferably choose a setting as 

low as possible when driving screws. Select 
a higher setting if the motor slips before the 
screw is fully tightened. 

•   For drilling, turn the torque adjustment ring (11) 

to the setting for drilling (

) by fully turning it 

counterclockwise. 

 Ensure that the direction switch (9) is 
always set to 

 during drilling. 

 The machine is equipped with electronic 
overload protection function. When the 
machine gets overloaded it will shut 
down automatically. When this happens, 
please wait for a few seconds to let the 
overload protection reset itself. 

4. MAINTENANCE

 Before cleaning and maintenance, always 
switch off the machine and remove the 
battery pack from the machine. 

Clean the machine casings regularly with a soft 
cloth, preferably after each use. Make sure that 
the ventilation openings are free of dust and 
dirt. Remove very persistent dirt using a soft 
cloth moistened with soapsuds. Do not use any 
solvents such as gasoline, alcohol, ammonia, 
etc. Chemicals such as these will damage the 
synthetic components.

ENVIRONMENT 

 Faulty and/or discarded electrical or 
electronic apparatus have to be collected 
at the appropriate recycling locations. 

Only for EC countries

Do not dispose of power tools into domestic 
waste. According to the European Guideline 
2012/19/EC for Waste Electrical and Electronic 
Equipment and its implementation into national 
right, power tools that are no longer usable must 
be collected separately and disposed of in an 
environmentally friendly way.

WARRANTY

FERM products are developed to the highest 
quality standards and are guaranteed free of 
defects in both materials and workmanship for the 
period lawfully stipulated starting from the date 
of original purchase. Should the product develop 
any failure during this period due to defective 
material and/or workmanship then contact your 
FERM dealer directly.