DeWalt DCD701D2 (MULTI) - Инструкция по эксплуатации - Страница 14

12

English

Optional Accessories

WARNING:

 Since accessories, other than those offered 

by 

D

e

WALT

, have not been tested with this product, use 

of such accessories with this tool could be hazardous. 
To reduce the risk of injury, only 

D

e

WALT

 recommended 

accessories should be used with this product.

Consult your dealer for further information on the 
appropriate accessories.

Protecting the Environment

Separate collection. Products and batteries marked 
with this symbol must not be disposed of with normal 
household waste.
Products and batteries contain materials that can 

be recovered or recycled reducing the demand for raw 
materials. Please recycle electrical products and batteries 
according to local provisions. Further information is available at 

www.2helpU.com

.

Rechargeable Battery Pack

This long life battery pack must be recharged when it fails 
to produce sufficient power on jobs which were easily done 
before. At the end of its technical life, discard it with due care for 
our environment:
•  Run the battery pack down completely, then remove it from 

the tool.

•  Li-Ion cells are recyclable. Take them to your dealer or a 

local recycling station. The collected battery packs will be 
recycled or disposed of properly.

Cleaning

WARNING:

 Blow dirt and dust out of the main housing 

with dry air as often as dirt is seen collecting in and around 
the air vents. Wear approved eye protection and approved 
dust mask when performing this procedure.

WARNING:

 Never use solvents or other harsh chemicals 

for cleaning the non-metallic parts of the tool. These 
chemicals may weaken the materials used in these parts. 
Use a cloth dampened only with water and mild soap. 
Never let any liquid get inside the tool; never immerse any 
part of the tool into a liquid.

Lubrication

Your power tool requires no additional lubrication.

MAINTENANCE

Your power tool has been designed to operate over a long 
period of time with a minimum of maintenance. Continuous 
satisfactory operation depends upon proper tool care and 
regular cleaning.

WARNING:To reduce the risk of serious personal 
injury, turn tool off and disconnect battery pack 
before making any adjustments or removing/
installing attachments or accessories. 

An accidental 

start-up can cause injury.

The charger and battery pack are not serviceable.

Recommendations for hammerdrilling

•  Too much force will cause slower drilling speeds, 

overheating, and a lower drilling rate.

•  A smooth even flow of material indicates the proper 

drilling rate.

•  Drill straight, keeping the bit at a right angle to the work. Do 

not exert side pressure on the bit when drillling as this will 
cause clogging of the bit flutes and a slower drilling speed.

•  When drilling deep holes, if the hammer speed starts to 

drop off, pull the bit partially out of the hole with tool still 
running to help clear debris from the hole.