Шуруповерты Black&Decker GoPak 12В USB BDCHD12S1 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
10
ENGLISH
(Original instructions)
Drilling in masonry
For drilling in masonry, set the collar (3) to
the hammer drilling position by aligning the
symbol with the marking. Slide the speed
selector (5) towards the front of the tool
(2nd gear).
Screwdriving
• Always use the correct type and size of
screwdriver bit.
• If screws are difficult to tighten, try
applying a small amount of washing
liquid or soap as a lubricant.
• A
lways hold the tool and screwdriver bit
in a straight line with the screw
Troubleshooting
Maintenance
Your BLACK+DECKER tool has been
designed to operate over a long period of
time with a minimum of maintenance.
Continuous satisfactory operation depends
upon proper tool care and regular cleaning.
Your charger does not require any
maintenance apart from regular cleaning.
Warning!
Before performing any
maintenance on the tool, remove the
battery from the tool. Unplug the
charger before cleaning it.
• Regularly clean the ventilation slots in
your tool and charger using a soft brush
or dry cloth.
• Regularly clean the motor housing using
a damp cloth. Do not use any abrasive or
solvent-based cleaner.
• Regularly open the chuck and tap it to
remove any dust from the interior.
Important!
To ensure product SAFETY and
RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this
manual) should be performed by authorized
service centers or other qualified
organizations, always using identical
replacement parts. Unit contains no user
service able parts inside.
Accessories
Recommended accessories for use with your
tool are available at extra cost from your
local dealer or authorized service center.
Warning!
The use of any accessory
not recommended for use with this
tool could be hazardous.
Batteries
BLACK+DECKER batteries can be
recharged many times. At the end of
their useful life, discard batteries with
due care for our environment:
• Run the battery down completely, then
remove it from the tool.
• NiCd, NiMH and Li-Ion batteries are
recyclable. Take them to any authorized
repair agent or a local recycling station.
Protecting the environment
Separate collection. This product
must not be disposed of with normal
household waste.
Should you find one day that your
BLACK+DECKER product needs replace-
ment, or if it is of no further use to you, do
not dispose of it with household waste. Make
this product available for separate collection.
Problem
Possible cause
Possible solution
Unit will not
start.
Battery pack
will not charge.
Charger not plugged
in.
Surrounding air
temperature too hot
or too cold.
Move charger and
battery pack to a
surrounding
airtemperature of
above 40degrees F
(45ºC) or below105
degrees F (+40.5ºC)
Battery pack not
charged.
Plug charger into
a working outlet.
Check battery pack
charging requirements.
Battery pack has
reached its
maximum thermal
limit.
Out of charge.
(To maximize the life
of the battery pack
it is designed to
shut off abruptly
when the charge is
depleted.)
Unit shuts off
abruptly.
Allow battery pack to
cool down.
Place on charger and
allow to charge.
