Black+DECKER EPC128BK - Инструкция по эксплуатации - Страница 7

7

ENGLISH

♦ 

The intended use is described in this 
instruction manual. The use of any accessory 
or attachment or performance of any operation 
with this tool other than those recommended 
in this instruction manual may present a risk of 
personal injury and/or damage to property.

Vibration

The declared vibration emission values stated in 
the technical data and the declaration of conformity 
have been measured in accordance with 
a standard test method provided by EN 60745 and 
may be used for comparing one tool with another. 
The declared vibration emission value may also be 
used in a preliminary assessment of exposure.

Warning! 

The vibration emission value during 

actual use of the power tool can differ from the 
declared value depending on the ways in which 
the tool is used. The vibration level may increase 
above the level stated.

When assessing vibration exposure to determine 
safety measures required by 2002/44/EC to 
protect persons regularly using power tools in 
employment, an estimation of vibration exposure 
should consider, the actual conditions of use and 
the way the tool is used, including taking account 
of all parts of the operating cycle such as the times 
when the tool is switched off and when it is running 
idle in addition to the trigger time.

Labels on tool

The following pictograms are shown on the tool:

Warning! 

To reduce the risk of injury, the 

user must read the instruction manual.

Additional safety instructions for batteries 
and chargers

Batteries

♦ 

Never attempt to open for any reason.

♦ 

Do not expose the battery to water.

♦ 

Do not store in locations where the 
temperature may exceed 40 °C.

♦ 

Charge only at ambient temperatures between 
10 °C and 40 °C.

♦ 

Charge only using the charger provided with 
the tool.

♦ 

When disposing of batteries, follow the 
instructions given in the section “Protecting the 
environment”.

Do not attempt to charge damaged 
batteries.

Chargers

♦ 

Use your Black & Decker charger only to 
charge the battery in the tool with which it was 
supplied. Other batteries could burst, causing 
personal injury and damage.

♦ 

Never attempt to charge non-rechargeable 
batteries.

♦ 

Have defective cords replaced immediately.

♦ 

Do not expose the charger to water.

♦ 

Do not open the charger.

♦ 

Do not probe the charger.

The charger is intended for indoor use 
only.

Read the instruction manual before use.

The charger automatically shuts off if the 
ambient temperature becomes too high. 
The thermal cut out operates only once 
and then requires complete replacement.

Electrical safety

Your charger is double insulated; therefore 
no earth wire is required. Always check 
that the mains voltage corresponds to the 
voltage on the rating plate. Never attempt 
to replace the charger unit with a regular 
mains plug.

♦ 

If the supply cord is damaged, it must be 
replaced by the manufacturer or an authorised 
Black & Decker Service Centre in order to 
avoid a hazard.

Features

This tool includes some or all of the following 
features.
1.  Variable speed switch
2. Forward/reverse 

slider

3.  Mode selector / torque adjustment collar
4. Chuck
5. Speed 

selector

6. Bit 

holder

7. Battery

Fig. A

8.

Charger plug

9. Charger
10. Charger receptacle

Assembly

Warning! 

Before assembly, remove the battery 

from the tool.