Bosch GWX 18V-15 SC X-LOCK (06019H6501) - Инструкция по эксплуатации - Страница 28

28

 | English

Battery charge indicator
(user interface) (24)

Meaning/cause

Solution

Yellow

Battery almost empty

Replace or charge battery soon

Red

Battery empty

Replace or charge battery

Temperature indicator (30) Meaning/cause

Solution

Yellow

Critical temperature has been reached (mo-
tor, electronics, battery)

Run the power tool at no load and allow it to
cool down

Red

Power tool is overheated and will switch off

Leave the power tool to cool down

Power tool status indic-
ator (29)

Meaning/cause

Solution

Green

Status OK

–

Yellow

Critical temperature has been reached or bat-
tery is almost empty

Run the power tool at no load and allow it to
cool down, or replace or charge the battery
soon

Illuminated red

Power tool has overheated or battery is empty Allow the power tool to cool down, or replace

or charge the battery

Flashing red

Kickback shutdown, restart protection or im-
pact shutdown has been triggered

Turn the power tool off and on again

Flashing blue

Power tool is connected to a mobile device or
settings are being transferred

–

Connectivity functions

In conjunction with the 

Bluetooth

® Low Energy Module

GCY 42

, the following connectivity functions are available

for the power tool:
– Registration and personalisation
– Status check, output of warning messages
– General information and settings
– Management
Read the corresponding operating instructions for informa-
tion about the 

Bluetooth

® Low Energy Module 

GCY 42

.

The connection of the power tool with the app must be con-
firmed by pressing the speed preselection button 

(26)

 on

the user interface 

(4)

. The app requests this when connect-

ing.

Practical advice

u

The power tool with inserted 

Bluetooth

®

Low Energy

Module

GCY 42 is equipped with a radio interface.

Local operating restrictions, e.g. in aircraft or hospit-
als, must be observed.

u

In areas where the 

Bluetooth

®

 wireless technology is

not allowed to be used, the 

Bluetooth

®

 Low Energy

Module GCY 42 and the button cell must be removed

.

u

Exercise caution when cutting slots in structural walls;
see the "Information on structural design" section.

u

Clamp the workpiece if it is not secure under its own
weight.

u

Do not load the power tool so heavily that it comes to a
stop.

u

If the power tool has been subjected to a heavy load,
continue to run it at no-load for several minutes to
cool down the accessory.

u

Do not use the power tool with a cut-off stand.

u

Do not touch grinding and cutting discs until they have
cooled down.

 The discs can become very hot while work-

ing.

If the power tool becomes electrostatically charged, the
built-in electronics will switch the power tool off. Press the
on/off switch 

(5)

 again to restart the power tool.

Rough grinding

u

Never use cutting discs for rough grinding.

The best rough grinding results are achieved with a set angle
of 30° to 40°. Move the power tool back and forth with mod-
erate pressure. This will ensure that the workpiece does not
become too hot or discolour and that grooves are not
formed.

Flap disc

The flap disc (accessory) enables you to machine curved
surfaces and profiles. 
Flap discs have a considerably longer service life, lower
noise levels and lower sanding temperatures than conven-
tional grinding discs.

Cutting metal

u

Always use the protective guard for cutting (12) when
cutting bonded abrasives.

When carrying out abrasive cutting, use a moderate feed
that is suited to the material being machined. Do not exert
pressure on the cutting disc and do not tilt or swing the
power tool.

1 609 92A 5RL | (19.06.2020)

Bosch Power Tools