Thomas GENIUS S1 ECO AQUAFILTER - Инструкция по эксплуатации - Страница 17

15

 What to do when ...

Should your THOMAS GENIUS S1 ECO AQUAFILTER not function to your satisfaction first check by means of the check list given below whether 
the cause of the irregularity is just a small matter before you contact the Customer Service Department.

Occurring irregularities,
faulty functions

Reasons, elimination 

General (all functions)

 The appliance cannot be started up

–  Are the mains connection cable, plug and plugbox in order? 

➔

 Before checking, disconnect 

the main power supply plug and only have any necessary repairs carried out by an authorised 
specialist

– Is the appliance switched on? 

➔

 Check

Dust vacuuming

 Dust is discharged when vacuuming

– Has the AQUAFILTER system been installed in accordance with the operating instructions?
–  Is suffi cient water in the dirty water tank and is the intake fi lter fully immersed in the water bath? 

➔

 Check

–  Is the intake fi lter blocked directly by dirt or are the nozzles blocked in the intake connector? 

➔

 Dismantle and clean or rinse out with water.

 Suction power slowly deteriorates

– Is the HEPA fi lter blocked? 

➔

 Clean the HEPA fi lter.

–  Are nozzles, suction tube or suction hose blocked by coarse dirt? 

➔

 Flexing the tube during 

operation will release any dust and dirt blocking the tube and clear the stoppage.

 Inadequate suction power

–  Is the Aqua injection nozzle blocked in the intake connector? 

➔

 Dismantle and clean or rinse out with 

water.

– Is the HEPA fi lter blocked? 

➔

 Clean HEPA fi lters.

–  Are nozzles, suction tube or suction hose blocked by coarse dirt? 

➔

 Flexing the tube during 

operation will release any dust and dirt blocking the tube and remove the stoppage.

–  Is the housing cover properly locked? 

➔

 Check.

– Is the mechanical suction power controller on  the hand grip open? 

➔

 Close the slider on the hand grip.

  A large number of drops of water 

have collected on the inside of the 
housing cover

–  In all probability there is too much dust in the AQUAFILTER system

   ➔

 Clean the AQUAFILTER system, renew the water

Liquid vacuuming

 The suction power decreases suddenly – Is the dirty water tank full (fl oat has responded)? 

➔

 Empty the tank.

–  Is the appliance standing at an angle (and has the fl oat responded? 

➔

 Stand the appliance up 

straight and switch the appliance off and on again.

  Is water escaping from the blow-out 

openings on the appliance

–  Is the fl oat in the dirty water tank dirty and is the fl oat switch no longer functional, i.e. it does not 

respond when the tank is full? Clean fl oat and hinge.

–  Has the dirty water tank been fi tted together with the anti-swash insert, wet fi lter and motor 

protection fi lter? -

➔

 Switch off the appliance immediately, dry the appliance and fi t missing parts.

  An unusually large pool of water has 

collected in the suction chamber (a few 
drops are absolutely normal)

–  Are the seals and sealing surfaces extremely dirty?

➔

 Clean.

– Have you forgotten to fi t the wet fi lter for the anti-swash insert. 

  Is residual moisture to high, liquid is no 

longer sucked up properly 

–  Is the mechanical suction power controller on  the hand grip open? 

➔

 Close the slider on the hand grip.

GB