Соответствие нормам; Идентификационный нормативный код модели - HP Ink Tank 115 - Инструкция по эксплуатации - Страница 75

Соответствие нормам

Принтер удовлетворяет требованиям к продуктам, разработанным регламентирующими органами 

вашей страны/региона.

Этот раздел содержит указанные ниже темы.

●

Идентификационный нормативный код модели

●

Положение FCC

●

Уведомление о соответствии нормам Европейского Союза

●

Устройства с внешними адаптерами переменного тока

Идентификационный нормативный код модели

Для нормативной идентификации устройству назначен нормативный номер модели. Этот нормативный 

номер модели не следует путать с торговым названием или номером продукта.

Положение FCC

The United States Federal Communications Commission (in 47 CFR 15.105) has specified that the following 

notice be brought to the attention of users of this product.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to 

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful 

interference in a residential installation. This equipment generates, uses and can radiate radio frequency 

energy and, if not installed and used in accordance with the instructions, may cause harmful interference to 

radio communications. However, there is no guarantee that interference will not occur in a particular 

installation. If this equipment does cause harmful interference to radio or television reception, which can be 

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by 

one or more of the following measures:

●

Reorient or relocate the receiving antenna.

●

Increase the separation between the equipment and the receiver.

●

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

●

Consult the dealer or an experienced radio/TV technician for help.

 NOTE: If the product has an Ethernet / LAN port with metallic casing then use of a shielded interface cable 

is required to comply with the Class B limits of Part 15 of FCC rules.

Modifications (part 15.21)

Any changes or modifications made to this device that are not expressly approved by HP may void the user’s 

authority to operate the equipment.

For further information, contact: Manager of Corporate Product Regulations, HP Inc. 1501 Page Mill Road, 

Palo Alto, CA 94304, U.S.A.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) 

this device may not cause harmful interference, and (2) this device must accept any interference received, 

including interference that may cause undesired operation.

RUWW

Соответствие нормам

71