Kuppersbusch IGS 6908.0 GE - Инструкция по эксплуатации - Страница 21

User instructions 

19 

•

Do not use table salt as it contains insoluble substances which, 
over time, may damage the water softening system. 

•

When necessary, refill the regenerating salt container before 
starting the washing program. In this way, the excess saline 
solution will be immediately removed by the water; the prolonged 
presence of salt water inside the tank may lead to corrosion. 

Be careful not to confuse the salt and detergent packages; adding 
detergent to the salt container will damage the water softening system. 

ADJUSTING THE WATER SOFTENING SYSTEM  

(available in all programs except the soak program) 

The dishwasher is equipped with an electronic device for adjusting the 
water softening setting according to the hardness of the water. To adjust 
the water softening setting, proceed as follows. 

•

 Keep 

the 

PROGRAM DELAY 

button

 (6) pressed for a few 

seconds

, until the 

H.-

 symbol, followed by the set value, appears on 

the 

3-FIGURE DISPLAY (12)

. 

•

 The 

PROGRAM DELAY 

button

 (6) 

can be pressed again to select 

the most suitable hardness value (

h.-0

, 

h.-1

, 

h.-2

…

h.-5

). Refer to 

the "Water hardness table" to select the value. 

•

To exit the programming mode press the 

START/PAUSE 

button

 (4)

or do not touch the keypad for 

2 seconds

 to allow the system to exit 

the mode automatically.