Kuppersberg GS 6005 - Инструкция по эксплуатации - Страница 21

21

ENGLISH

TECHNICAL PASSPORT

Dishwasher

NOTE: 

If operate from step 1 to step 

2,  the  fi lter  system  will  be  removed; 

while operate from step 2 to step 1, the 

fi lter system will be installed.

 Filter  assembly

For best performance and results, 

the fi lter assembly must be cleaned. The 
fi lter  effi ciently  removesfood  particles 

from the wash water, allowing it to 
be recirculated during the cycle. For 
this reason, itis a good idea to remove 
the larger food particles trapped in 

the  fi lter  after  each  wash  cycle  by 
rinsingthe  semicircular  fi lter  and  cup 

under running water. To remove the 

fi lter  assembly,  pull  on  the  cuphandle 

in the upward direction. The entire 

fi lter assembly should be cleaned once 
a  week.  To  cleanthe  coarse  fi lter  and 
the  micro  fi lter,  use  a  cleaning  brush. 
Then,  reassemble  the  fi lter  parts  as 
shownin the fi gures above and reinsert 

the entire assembly in the dishwasher, 
positioning in its seat andpressing 
downward. The dishwasher must never 

be  used  without  the  fi lters.  Improper 

replacementof the fi lter may reduce the 

performance level of the appliance and 
damage dishes and utensils.

WARNING!

Never run the dishwasher without 

the  fi lters  in  place.  When  cleaning  the 
fi lters, don’t knock on them. Otherwise, 
the  fi lters  could  be  contorted  and  the 

performance of dishwasher could be 
debased.

Cleaning the Spray Arms

It is necessary to clean the spray 

arms regularly for hard water chemicals 
will clog the spray arm jets and 
bearings.

To remove the spray arms, screw 

off the nut clockwise to take out the 
washer on top of the spray arm and 
remove the arm. Wash the arms in 
soapy and warm water and use a soft 
brush to clean the jets. Replace them 
after rinsing thoroughly.