Makita HS6601 - Инструкция по эксплуатации - Страница 9

9 ENGLISH

Connecting a vacuum cleaner

Optional accessory

When you wish to perform clean cutting operation, connect 

a Makita vacuum cleaner to your tool. Connect a hose of the 

vacuum cleaner to the dust nozzle as shown in the figure.

1

2

►  

1.

 Dust nozzle 

2.

 Screw

2

１

►  

1.

 Hose 

2.

 Vacuum cleaner

OPERATION

CAUTION:

Be sure to move the tool forward 

in a straight line gently.

 Forcing or twisting the tool 

will result in overheating the motor and dangerous 

kickback, possibly causing severe injury.

Hold the tool firmly. The tool is provided with both a front 

grip and rear handle. Use both to best grasp the tool. 

If both hands are holding saw, they cannot be cut by 

the circular saw blade. Set the base on the workpiece 

to be cut without the circular saw blade making any 

contact. Then turn the tool on and wait until the circular 

saw blade attains full speed. Now simply move the tool 

forward over the workpiece surface, keeping it flat and 

advancing smoothly until the sawing is completed.

To get clean cuts, keep your sawing line straight and 

your speed of advance uniform. If the cut fails to prop-

erly follow your intended cut line, do not attempt to turn 

or force the tool back to the cut line. Doing so may bind 

the circular saw blade and lead to dangerous kickback 

and possible serious injury. Release switch, wait for cir

-

cular saw blade to stop and then withdraw tool. Realign 

tool on new cut line, and start cut again. Attempt to 

avoid positioning which exposes operator to chips and 

wood dust being ejected from saw. Use eye protection 

to help avoid injury.

Rip fence (Guide rule)

Optional accessory

2

１

►  

1.

 Rip fence (Guide rule) 

2.

 Clamping screw

The handy rip fence allows you to do extra-accurate 

straight cuts. Simply slide the rip fence up snugly 

against the side of the workpiece and secure it in posi-

tion with the clamping screw on the front of the base. It 

also makes repeated cuts of uniform width possible.

MAINTENANCE

CAUTION:

Always be sure that the tool is 

switched off and unplugged before attempting to 

perform inspection or maintenance.

CAUTION:

Clean out the guard to ensure 

there is no accumulated sawdust and chips 

which may impede the operation of the guarding 

system.

 A dirty guarding system may limit the proper 

operation which could result in serious personal 

injury. The most effective way to accomplish this 

cleaning is with compressed air. 

If the dust is being 

blown out of the guard, be sure the proper eye 

and breathing protection is used.

NOTICE:

Never use gasoline, benzine, thinner, 

alcohol or the like. Discoloration, deformation or 

cracks may result.