Makita HS6601 - Инструкция по эксплуатации - Страница 10

10 ENGLISH

Adjusting the parallelism

1

A

B

►  

1.

 Screw

This adjustment has been made at the factory. But if it is 

off, you can adjust it as the following procedure.

1.

Make sure all levers and screws are tightened. 

Slightly loosen the screw illustrated.

2.

While opening the lower guard, move the rear of 

the base so that the distance A and B becomes equal.

3.

Tighten the screws and make a test cut to check 

the parallelism.

Adjusting 0°-cut accuracy

1

►  

1.

 Adjusting bolt

1

0

2

►  

1.

 Triangular rule 

2.

 Clamping screw

This adjustment has been made at the factory. But if it is 

off, you can adjust it as the following procedure.

1.

Slightly loosen the clamping screws on the front 

and rear of the tool.

2.

Make the base perpendicular to the blade using 

a triangular rule or square rule by turning the adjusting 

bolt.

3.

Tighten the clamping screws and make a test cut 

to check the verticalness.

Replacing carbon brushes

1

►  

1.

 Limit mark

Check the carbon brushes regularly.

Replace them when they wear down to the limit mark. 

Keep the carbon brushes clean and free to slip in the 

holders. Both carbon brushes should be replaced at the 

same time. Use only identical carbon brushes.

1.

Use a screwdriver to remove the brush holder

caps.

2.

Take out the worn carbon brushes, insert the new

ones and secure the brush holder caps.

1

►  

1.

 Brush holder cap

To maintain product SAFETY and RELIABILITY, 

repairs, any other maintenance or adjustment should 

be performed by Makita Authorized or Factory Service 

Centers, always using Makita replacement parts.