Fieldmann FDUK 50301 - Инструкция по эксплуатации - Страница 25

EN

CORDLESS CIRCULAR SAW

OPERATING INSTRUCTIONS

25

Technical data

11. TECHNICAL DATA

CORDLESS CIRCULAR SAW:

Nominal voltage

18V

Speed

3 800rpm

Protection class

II

Blade Diameter:

136 mm

vibration level

1.742 ms

-2

 ,      K=1.5ms

-2

Declared noise level

91.9dB(A),       K=3dB(A)

Troubleshooting

1. The trigger is pressed but the device is not working: For the cordless device to work, you

need a sufficiently charged battery. The battery will go flat if you do not use the cordless

device for an extended period of time. Try charging the battery. Check that the battery is

correctly seated in the charger. The charger will heat up while charging, this is normal.

2. The battery is leaking: At extreme temperatures or when under extreme load, a small

amount of leakage may occur. If you happen to touch the fluid, immediately wash it off

your skin or clothing with soap and water.

3. The battery is not charging and the light on the charger is not lit: If the battery is not

charging, check that it is correctly seated in the charger and check that the indicator light

is lit. If it is not lit, check that the power plug of the charger is correctly plugged into the

socket. If it is, check the socket's fuse/circuit breaker.

4. The body of the device heats up after extended use: Under normal load the body, trigger

and battery will heat up because the energy consumed when drilling generates heat. This is

normal. Simply allow the device to cool down for several minutes.

5. The battery heats up during use: Energy drawn from the battery generates heat. It does

not damage the battery, heat from drawing energy is normal. If you wish to cool the battery

down, allow the device to cool down for a few minutes before continuing with work.

6. The battery heats up while charging: This is normal and is the result of chemical reactions

taking place inside the battery during the charging process.

7. The charging unit will heat up while charging: This is normal and is caused by the

reduction of voltage from 230V to 18V.

Instructions Manual - language version only.

Amendments to text and technical parameters are reserved.

Changes in the text, design and technical specifi cations may change without prior notice and 

we reserve the right to make these changes.keep it from turning as the drill bit rotates.