Bosch GSH 11 VC - Инструкция по эксплуатации - Страница 10

10

 | English 

1 609 92A 0FH | (10.12.13)

Bosch Power Tools

Delivery Scope

Demolition hammer, auxiliary handle.
Application tools and other accessories shown or described 
are not part of the standard delivery scope.

A complete overview of accessories can be found in our ac-
cessories program.

Intended Use

The machine is intended for chiselling work in concrete, brick, 
masonry and asphalt as well as for driving in and compacting, 
when using the respective accessories.

Technical Data

The technical data of the machine are listed in the table on 
page 143.

The values given are valid for a nominal voltage [U] of 230 V. 
For different voltages and models for specific countries, 
these values can vary.

Declaration of Conformity

We declare under our sole responsibility that the product de-
scribed under “Technical Data” is in conformity with the fol-
lowing standards or standardization documents: EN 60745 
according to the provisions of the directives 2011/65/EU, 
2004 / 108 / EC, 2006/42/EC, 2000 / 14 / EC.
2000 / 14 / EC: Guaranteed sound power level 105 dB(A). 
Conformity assessment procedure according to Annex VI.

Equipment category: 10

Notified body:
TÜV NORD CERT GmbH & Co. KG, 
Am TÜV 1, 30519 Hannover

Technical file (2006/42/EC, 2000/14/EC) at:
Robert Bosch GmbH, PT/ETM9,
D-70745 Leinfelden-Echterdingen

Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
10.12.2013

Noise/Vibration Information

The measured values of the machine are listed in the table on 
page 143.

Noise and vibrational values (vector sum of three directions) 
determined according to EN 60745.

The vibration level given in this information sheet has been 
measured in accordance with a standardised test given in 
EN 60745 and may be used to compare one tool with anoth-
er. It may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main ap-
plications of the tool. However if the tool is used for different 
applications, with different accessories or insertion tools or is 
poorly maintained, the vibration emission may differ. This 
may significantly increase the exposure level over the total 
working period.
An estimation of the level of exposure to vibration should also 
take into account the times when the tool is switched off or 
when it is running but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total working 
period.
Identify additional safety measures to protect the operator 
from the effects of vibration such as: maintain the tool and the 
accessories, keep the hands warm, organisation of work pat-
terns.

Mounting and Operation

The following table indicates the action objectives for mounting and operation of the power tool. The instructions for each action 
objective are shown aside. Depending on the type of application, various instruction combinations are required. Observe the 
safety instructions.

Henk Becker
Executive Vice President
Engineering

Helmut Heinzelmann
Head of Product Certification
PT/ETM9

Action

Figure

Please observe

Page

Insert the SDS-max application 
tool

1

144

Removing the SDS-max application 
tool

2

144

Changing the chisel position 
(Vario-Lock)

3

145

OBJ_BUCH-1391-003.book  Page 10  Tuesday, December 10, 2013  12:51 PM