Обогреватели Timberk T-IR2000-A12SI - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
IM2022
16
NOTE:
Radiating plate should be wiped with a soft rag moistened in alcohol. The rag must not leave
scratches on the surface. Use of other liquids is prohibited!
11. TROUBLESHOOTING
If it is impossible to fix these malfunctions with these methods, contact the authorized service
center.
Malfunction
Possible cause
Solution
The device is connected
to the network but doesn’t
work.
No power
Check whether the power
supply is disconnected from
the device and, if necessary,
connect device to power
supply
Temperature controller is set
to low room heating
temperature (If you have
remote temperature
controller)
Set the temperature controller
to the higher room heating
temperature by rotating the
handle of the controller
clockwise (If you have remote
temperature controller)
Malfunction in circuit breaker
Change the circuit breaker
Power cord is broken
Contact an authorized service
center to fix it
Faulty contact connection in
wiring scheme of electrical
circuit
Contact an authorized service
center or restore reliable
contact connection
Electrical circuit of heating
element malfunction
Contact an authorized service
center
Defective heating element
Contact an authorized service
center
Heating is not good enough
Low voltage in power network
Check power network
Temperature controller is set
to low room heating
temperature (If you have
remote temperature
controller)
Set the temperature controller
to the higher room heating
temperature by rotating the
handle of the controller
clockwise (If you have remote
temperature controller)
Severe damage of the coating
of emitting panels
Contact an authorized service
center
Room temperature is higher
than the temperature selected
by temperature controller (If
you have remote temperature
controller)
Turn the controller handle to
the highest temperature (If
you have remote temperature
controller)
