MO-EL Fiore 1200 W Shuko 766N - Инструкция по эксплуатации - Страница 9

9

9.  Avoid the use of an extension cord with this product, because 

the extension cord may overheat and cause a risk of fire.

10. 

Do not apply any modification to the product that could compro

-

mise the safety.

11. Keep connections dry.

12. If the power supply cord is damaged, avoid to use the appliance. 

For power cord replacing, please contact the manufacturer or the 

technical service or a person with similar qualification, in order to 

avoid any risk.

13. If the appliance is not used for a long period, disconnect it from 

the power supply.

14. Always unplug the appliance before doing any maintenance op-

eration.

2.  ELECTRICAL INSTALLATION  

The installation should always be carried out by a qualified 

electrician or a competent person in accordance with the 

standards HD 384 CENELEC for Europe, or international IEC 

60346-7-708 1988. The energy supply must be done through a prop-

erly grounded socket and the impedance of the electrical network 

must be  less than 0.3 ohm.
In case of directly connection to supply line an overvoltage category 

III bipolar circuit breaker with contact opening distance of at least 3 

mm must be fitted upstream from the supply line. 
Be careful to connect the heater to a supply line protected by 16 A 

fuses not quick-acting type.

• 

The heaters should always be installed horizontally only using the 

mounting brackets provided. This ensures correct positioning and 

adequate clearance.

• 

A minimum air gap of 40 cm should always be allowed between 

the top of the heater and a ceiling or roof. The appliance should be 

60 cm far from the walls (fig.1).

• 

A safety distance of not less than 100 cm should always be left in 

front of the FIORE heaters or too near.

• 

This unit should be mounted at a minimum of 180 cm above ground 

level (fig.1).  If installed in a toilet, the height should be 225 cm in