MO-EL Fiore 1200 W Shuko 766N - Инструкция по эксплуатации - Страница 12

12

Avoid exposing skin to the rays of the appliance for distances 

less than 50 cm.
Avoid exposing eyes to the rays of the appliance for distances 

less than 2.70 m.

All users should be made aware of all aspects of operation and safety 

and these instructions should be retained for reference.

Switch  on  heater  (in  the  models  that  have  the  switch)  and  confirm 

that emitter is operating. Ensure that the heater is aiming its warmth 

into the target area by adjusting heater angles as necessary by us-

ing the adjustment device on the bracket, after you have loosed the 

screws of the half rings (fig.6). 

Do not use the heater directly near a bathtub, a shower, a swimming 

pool. In unoccupied premises it is recommended that the heating 

system is switched off and isolated from the electrical supply.

5.  MAINTENANCE

Mo-El Fiore heaters contain no moving parts and therefore very little 

maintenance is required other than to ensure that there is no exces-

sive  build-up  of  dust/dirt  on  the  reflectors  or  emitters  as  this  can 

cause overheating and premature emitter failure. To clean the appli-

ance, wipe off with a damp cloth.
The accumulation of limestone or incrustations reduces the life and 

the efficiency of the lamp; it is suggested therefore to avoid the con

-

tinued use in presence of water or salt fog. Eventual leavings of salt 

water will have to be removed before the use, after having discon-

nected the appliance, by means of soak in sweet water.

6.  EMITTER AND SILICON BUMPERS REPLACEMENT 

The emitters used in the Fiore are robust and if knocks and shock 

vibrations are avoided, they will last for around 5000 hours. When 

changing the lamp, also the silicon bumpers connected with the 

lamp must be substituted. They should be substituted even before 

if there are signs of aging. Due to the special sealing and anti-shock 

design of the heater, the emitters are not intended to be user re-

placeable. Please ensure that all emitters are replaced via the Mo-El 

service network.