VITEK VT-3520 BK - Инструкция по эксплуатации - Страница 6

ENGLISH

6

3.   Use the (7) and the (9) buttons to select a time format.
4.   Press the “SET.MEM” (2) button

. 

Digits (hours) will start flashing on the display.

5.   Use the (7) and the (9) buttons to select the required hour.
6.   Press the “SET.MEM” (2) button

. 

Digits (minutes) will start flashing on the display.

7.   Use the (7) and the (9) buttons to select the required minutes value.

Note: If during setting, the (7) or (9) buttons are not pressed during 10 seconds, the unit will 

switch to the current time mode

.

Setting the alarms (AL.1 

and 

AL.2) activation (actuation) time

1. Plug in the unit.
2. To view the current settings of the first alarm press the “AL.1” (3) button.
3. In the alarm current settings display mode, to change the settings press and hold the “AL.1” (3) 

again. Hour digits will start flashing on the display.

4. Use the (7) and the (9) buttons to select the required hour.
5. Press the “AL.1” (3) button. Minutes digits will start flashing on the display. 
6. Use the (7) and the (9) buttons to select the required minutes.
7. Press the “AL.1” (3) button. Symbols of alarm signal types will be flashing on the display.  Use the 

(7) and the (9) buttons to select the required signal type: radio (RADIO), iPod/iPhone (the corre-
sponding symbol) or a sound signal (BEEP).

8. Repeat actions 2-8 for the second alarm “AL.2” (5).

Note: 

If during setting, the (7) or (9) buttons are not pressed during 10 seconds, the unit will 

− 

switch to the current time mode

.

The alarm is actuated only when the unit is connected to the mains.  

− 

If you select iPod/iPhone as an alarm signal, make sure that the unit is properly inserted in 

− 

the jack (4); otherwise the alarm will not be actuated.

Switching on/off of the alarms

1. To switch on the alarm (s) press and hold the 

“AL.1”

 (3) / 

“AL.2”

 (5) 

button until the alarm (s) switch-

ing on symbol (13) appears on the display. 

2. To switch off the alarm press and hold the corresponding button once again.

Repeat the alarm signal

1.  You can delay the alarm signal for 9 minutes by pressing the (10) “SNOOZE/SLEEP” button. In 9 

minutes the alarm signal will be repeated.

2. 

To switch off the sound signal of the alarm-clock press the button of the corresponding alarm (3) 
“AL.1”/(5) “AL.2”. If radio is selected as the source of sound signal it will switch off automatically 
after 1 hour.  

Note: The alarm signal will be ringing for an hour, if you do not press any buttons.

Setting the display brightness (13)

1.  Plug in the unit.
2.  Repeatedly pressing the “DIMMER” (10) button, set the required brightness of the display.

Timer

You can set time after which the clock radio will switch off automatically.
1.  Connect the unit to the mains and press the on/off button (1).

3520.indd   6

3520.indd   6

23.08.2011   17:06:45

23.08.2011   17:06:45