Lavor STM 160 WPS 8.086.0140C - Инструкция по эксплуатации - Страница 15

EN

15

lem repeats again or if the product does not 
start again, take the product to the nearest 
After Sales Service Point

>  STABILIT Y 

 WARNING: 

 The machine must be always kept 

on horizontal bases, in a safe and stable way.

USAGE

>  

DESCRIPTION OF THE MACHINE

   See  the specific instructions manual provided.

>  

ASSEMBLY INSTRUCTIONS

   See  the specific instructions manual provided.

>  

PUT INTO SERVICE

See 

fig.

>  

STARTING UP

See 

fig.

>  

HIGH PRESSURE LANCE

See 

fig.

>  

DETERGENT SUCTION

See 

fig.

>  

HIGH PRESSURE HOSE

See 

fig.

>  

WATER SUPPLY

   Water supply collection

Water supply from the water main
·  Connect a supply hose (not included) to the 

water inlet of the unit and to the water supply.

·  Open the water supply.

WARNING:

 (symbol) machine not suitable 

for connection to the potable water mains.

The cleaner can only be connected to the wa-
ter mains if the water mains is separated by a 
backflow preventer. Make sure that the hose 
is at least Ø 13mm-1/2 inch and that it is rein-
forced.

 WARNING:

 Water that has flown through 

backflow preventers is considered to be 
nonpotable.

IMPORTANT:

 Only clean or filtered water 

should be used for intake. The delivery of the 
water intake tap should be equal to the double 
of the maximum pump range. 

-    Minimum delivery rate: 15 l/ min.
-    Maximum intake water temperature: 40°C
-    Max inlet water pressure: 1Mpa
Place the cleaner as close to the water supply 
system as possible.

Water supply from an open container
·  Unscrew the coupling part for the water inlet.
·  Screw the suction hose with filter (not included) 

onto the water connection of the unit.

·  Hang the filter in the container.
·  Vent the unit before operation.
·  Unscrew the high-pressure line at the high-

pressure outlet of the unit.

·  Switch on the unit and let it run until water 

free of bubbles emerges at the high-pressure 
outlet.

·  Switch off the unit and screw on the high-

pressure hose again.

Failure to comply with the above conditions 
causes serious mechanical damage to the 
pump and the loss of warranty cover.

>  

ELECTRICIT Y SUPPLY

-   The appliance’s electrical connection must 

comply with the IEC 60364-1 standard.

 IMPORTANT:

 Before connecting the 

appliance, make sure that the nameplate data 
are the same as those of the electrical mains 
and that the socket is protected by a differential 
security breaker with tripping sensitivity below 
0.03 A - 30 ms.

-   If the appliance’s plug is not compatible with 

the socket, have the socket replaced with 
another  of  suitable  type  by  professionally 
qualified staff.

-  

Never use the appliance in ambient 

temperatures below 0° C if it is equipped with a 
PVC (H VV-F) cable.

 XY WARNING: 

Inadequate extension cords 

can be dangerous.

 XJ WARNING:

 If an extension cord is used, 

the plug and socket must be of watertight 
construction. 

   Information for supply may also be obtained