Мойки высокого давления Karcher HD 10/15-4 CAGE F 1.524-230 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
14
English
Î
Check connection cable for damages
(risk of electrical shock); get the dam-
aged connection cable replaced imme-
diately by an authorised customer
service person/ electrician.
Î
Check the high pressure hose for dam-
ages (risk of bursting).
Please arrange for the immediate ex-
change of a damaged high-pressure
hose.
Î
Check appliance (pump) for leaks.
3 drops per minute are permitted and
can come out from the lower side of the
appliance. Call Customer Service if
there is heavy leakage.
Î
Check oil level Please contact Custom-
er Service immediately if the oil is milky
(water in oil).
Î
Clean the sieve in the water connection.
Î
Clean filter at the detergent suck hose.
Î
Get customer service to change the oil.
Note
See "Technical Details" for details of oil
quantity and type.
Danger
First pull out the plug from the mains before
carrying out any tasks on the machine.
Get the electrical components checked and
repaired only by authorised customer serv-
ice persons.
Contact an authorised customer service
person in case of problems not mentioned
in this chapter or if you are in doubt or when
you have been explicitly asked to do so.
Î
Check connection cable for damages.
Î
Check the supply voltage.
Î
Lack of water fuse was triggered:
Check the water input, open the tap,
have the lack of water fuse tested by
customer service.
Î
Call Customer Service in case of elec-
trical defects.
Î
Install the high pressure or rotor nozzle
on the spray pipe.
Î
Clean the nozzle.
Î
Replace the nozzle.
Î
Deaerate the appliance (see "Start-up")
Î
Unscrew the locking screw of the ad-
vance pump with a screwdriver through
the opening in the advance pump.
Loosen the shaft of the advance pump
by turning it.
Screw in the lock screw and tighten it.
Î
Check water supply level (refer to tech-
nical data).
Î
Clean the sieve in the water connection.
Î
Check all inlet pipes to the pump.
Î
Contact Customer Service if needed.
3 drops per minute are permitted and can
come out from the lower side of the appli-
ance.
Î
With stronger leak, have device
checked by customer service.
Note
Water drops can escape from the swimmer
container during operation and exit from
the appliance. This is normal and must not
be mistaken for a leaking pump.
Î
Check suction pipes for water and de-
tergent and ensure that they are leak-
proof.
Î
Close dosing valve for detergent to op-
erate the machine without detergent.
Î
Deaerate the appliance (see "Start-up")
Î
Contact Customer Service if needed.
Before each use
Weekly
monthly or after 500 operating
hours
Troubleshooting
Appliance is not running
Pressure does not build up in the
appliance
Pump leaky
Pump is vibrating
