Karcher HD 10/15-4 CAGE F 1.524-230 - Инструкция по эксплуатации - Страница 12

12 

English

–

The minimum fuse rating required at the 
socket outlet is (see technical specifica-
tions).

–

The appliance should always be con-
nected to the electrical mains using a 
plug. It is forbidden to permanently con-
nect the appliance to the power supply. 
The plug is only for mains separation.

–

Check the power cord with mains plug 
for damage before every use. If the 
power cord is damaged, please arrange 
immediately for the exchange by an au-
thorized customer service or a skilled 
electrician.

–

The plug and coupling of the extension 
cable used must be watertight.

–

Use the extension cord that has an ad-
equate cross-section (see "Technical 
Data") and unwind it fully from the cable 
drum.

–

Unsuitable extension cables can be 
hazardous. Only use extension cables 
outdoors which have been approved for 
this purpose and labelled with a suffi-
cient cable cross section:

For connection values, see type plate/tech-
nical data.

몇

Warning

Observe regulations of water supplier. 

For connection values refer to technical 
specifications

Î

Connect the supply hose (minimum 
length 7.5 m, minimum diameter 1“) to 
the water connection point of the appli-
ance (such as the tap).

Note

The supply hose is not included.

Î

Open the water supply.

Î

Deaerate the appliance:
Unscrew the nozzle. 
Switch on the appliance and let it run 
until the water exiting is bubble-free. 

At the end let the appliance run for ap-
prox. 10 seconds - then switch off. Re-
peat the procedure for a couple of 
times.

Î

Switch off the appliance and fit the noz-
zle again. 



Danger

If the appliance is used in hazardous areas 
(e.g. filling stations) the corresponding 
safety provisions must be observed.

몇

Warning

Clean engines only at places with corre-
sponding oil separators (environmental 
safety).
The jet must not be directed at other per-
sons or directed by the user at him/herself 
to clean clothing or footwear.

Note

The appliance is equipped with a pressure 
switch. The motor starts up only when the 
lever of the pistol is pulled.

Î

Set the appliance switch to "I".

Î

Unlock the hand-spray gun and pull the 
lever of the gun.

Î

Set working pressure and flow rate 
through turning (rungless) at the pres-
sure- and amount regulation (B) (+/-).

Î

Close the hand spray gun. 

Î

Set the appliance switch to "0".

Î

Install the desired nozzle on the spray 
pipe.

몇

Warning

Unsuitable detergents can cause damage 
to the appliance and to the object to be 
cleaned.  Use only those detergents that 
have been approved by Kärcher. Observe 
the dosage and other instructions provided 
with these detergents. For considerate 

Water connection

Connection to the water supply

Operation

High pressure operation

Select spray type

Operation with detergent