IPC Portotecnica HPS DS2015T 44520 IDAC - Инструкция по эксплуатации - Страница 26

English

- 26 -

TABLE OF 

EXTRAORDINARY MAINTENANCE

 TO 

BE PERFORMED BY THE TECHNICAL SERVICE 

CENTRE

Descrizione  operazioni:

Boiler:

Clean Coil
Descale coil

Clean fuel pump
Change fuel nozzle
Regulade electrodes
Change electrodes

Change seals on H.P. pump
Change lanze nozzle
Calibrate and check the safety devices

IMPORTANT:

These intervals refer to normal working conditions. For heavy duty use decrease the interval for each job.

For maintenance and/or repairs, use only original spare parts which offer the greatest characteristics of quality and 

reliability. Failure to use original spare parts absolves the manufacturer from all liability and transfers it to the

person carrying out the operation.

PERIODS OF INACTIVITY

If the machine is to remain inactive for a long period, disconnect the supply sources, drain the tank(s) of all the operating fluids 

and protect any parts that could be damaged by the accumulation of dust.

Grease the parts that could be damaged by drying out, such as the supply hoses.  When bringing back into use, ensure that 

there are no cracks or cuts in the water supply hoses.

Oil and chemical products must be disposed of according to current legislation.

SCRAPPING

If you no longer wish to use the water cleaner, you should render it unusable by removing the power cable. 

You should also make sure that all potentially hazardous parts of the appliance are made safe, particularly for children who could 

play with the unused water cleaner. 

This  product  is  classified  as  WEEE  type  special  waste  and  is  covered  by  the  requisites  of  the  new  environmental  protection 

regulations. It must be disposed of separately from ordinary waste in compliance with current legislation and standards.

Do not use parts dismantled for scrap as spare parts.

Every 200 hours
Every 300 hours

Every 200 hours
Every 200 hours
Every 200 hours
Every 500 hours

Every 500 hours
Every 200 hours
Once a year

Each use

After 50 hours
Every 500 hours

Every 100 hours
Every 100 hours
Every 50 hours

TABLE OF ROUTINE MAINTENANCE TO BE PER-

FORMED BY THE USER

Description of operations:

Check power cable - pipes - high pressure
connectors

Ist oil change in H.P. pump
Subsequent changes in H.P. pump

Change and clean fuel filters
Clean fuel tank
Clean water filter

CHANGING THE NOZZLE

The  high  pressure  nozzle  fitted  on  the  lance  must  be 

changed from time to time, as this component is subject to 

normal wear during use.  Wear may generally be detected 

by a drop in the working pressure of the cleaner.  To replace 

it, consult your supplier and/or dealer for instructions.

DESCALING

Descaling must be carried out from time to time because the 

scale present in the water partially deposits inside the hydraulic 

circuit and the coil which with time becomes clogged.  

Apply to our technical service centre to have the machine 

descaled from time to time; this will save you money and 

increase the efficiency of the cleaner.