Bosch AQT 42-13 0.600.8A7.300 - Инструкция по эксплуатации - Страница 12

12

 | English 

F 016 L81 056 | (11.4.14)

Bosch Power Tools

Power supply



The voltage indicated on the rating 
plate must correspond to the volt-
age of the power source.



We recommend that this equipment 
is only connected into a socket 
which is protected by a circuit-
breaker that would be actuated by a 
30 mA residual current.



Remove the plug from socket when-
ever the machine is left unattended 
for any period.



The electric supply installation 
should comply with IEC 60364-1.



If the supply cord is damaged, it 
must be replaced by the manufac-
turer, its service agent or similarly 
qualified persons in order to avoid a 
hazard.



If the plug is damaged, pay attention 
to the following:



Plugs and sockets situated near the 
work site or outdoors should be to 
class IP 55 of BS 5490 to provide 
adequate protection against ingress 
of water, etc. and cable entries re-
quire effective sealing. Rubber 
shrouds should be provided over ca-
ble glands. Drip-proof (class IP X2 of 
BS 5490) plugs and sockets to 
BS 4343 are suitable for use in-
doors where the plug is away from 
the water spray area where the ap-
pliance is in use.



Never touch the mains plug with wet 
hands.



Do not pull plug while operating the 
device.



Do not run over, crush or pull the 
power supply cable or extension 
lead, otherwise it may be damaged. 
Protect the cable from heat, oil and 
sharp edges.



Do not use the appliance, if the pow-
er supply cable or important parts, 
e. g. high-pressure hose, trigger gun 
or safety devices are damaged.



Warning: Inadequate extension 
cords can be dangerous.



If an extension cord is used, the plug 
and socket must be of watertight 
construction. The extension cord 
must have a cross section in accord-
ance with the operating instructions 
and be protected against splashed 
water. The connection must not be 
in water.



When replacing plugs on the power 
supply cable or extension lead the 
spray water guard and mechanical 
stability must remain intact.

Water connection



Comply with the regulations of your 
water supply company.



All connecting hoses must have 
properly sealed joints.



Make sure that the supply hose is at 
least 12.7 mm (1/2") in diameter 
and is reinforced.



The appliance should never be used 
on the drinking water supply with-
out a back flow valve. Water which 
has passed the back flow valve is re-
garded as undrinkable.



The high-pressure hose must not be 
damaged (danger of bursting). A 
damaged high-pressure hose must 

OBJ_BUCH-2164-001.book  Page 12  Friday, April 11, 2014  12:41 PM