Морозильные камеры Ardesto IM-A1200SS - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
28
EN
Failure
Cause
Solution
Power indication light is
not on.
The power plug is not
plugged well or there is no
electricity in the socket.
Plug the power plug correctly
into the socket and make sure
it is connected separately.
The device has abnormal
noise.
1. The device is not stably.
2. The voltage is too low.
3. The fan has foreign body.
1. Please install the product in
a flat position.
2. Please cut off the power
supply and check if there is
problem with voltage.
3. Firstly please cut off the
power supply and then check
if there is foreign body in the
fan.
On the operation panel,
the red ice full indication
light is on, but there is no
ice in the icebox.
1. Infrared sensor adheres to
foreign object.
2. Infrared sensor is broken;
circuit board is broken.
1. Please cut off the power
supply of the product and
remove the foreign object
adhered to the infrared sensor.
2. Please stop using the
product and contact
authorized service center.
On the operation panel,
the lack indication is on
but there is plenty of
water in the tank.
1. Maybe the pump is broken.
2. The water supply system is
blocked by impurities.
Please stop using the product
and contact authorized service
center.
Ice is mixed with
impurities.
There are impurities in the
water tank.
Please rinse the interior of the
water tank.
The ice has odor.
Due to water quality or the
ice produced first time after
purchase.
After using it several times, the
odor will disappear.
“Lack” indication light is
on.
1. Lack of water.
2. The bottom of the water
tank is blocked.
Stop ice making, add water
and press “ON/OFF” to start ice
making again.
“Ice Full” indication light
is on.
1. There are too many ice in
the ice bucket.
2. The ice full sensor is
broken, there is no ice, but
the “Full” indication light is
on.
1. Take the ice from the ice
bucket.
2. Please stop using the
product and contact
authorized service center.
TROUBLESHOOTING GUIDE
Характеристики
Остались вопросы?Не нашли свой ответ в руководстве или возникли другие проблемы? Задайте свой вопрос в форме ниже с подробным описанием вашей ситуации, чтобы другие люди и специалисты смогли дать на него ответ. Если вы знаете как решить проблему другого человека, пожалуйста, подскажите ему :)
